SL-FL39 DIN 4102 Smoke Density Fire Tester
DIN 4102 İnşaat Malzemesi Yanıcılık Test Cihazları / duman Yoğunluk Yangın Tester
Product introduction of the Smoke Density Fire Tester
Ayrıca yanma veya bozunma kontrollü koşullar altında yapı malzemesi, ve somke üreten karakteristiğini ölçme için kullanılan uygun diğer plastikler için kullanılabilir.
Standartlar
ASTM D 28-43, 4102 DIN
Product Specification of the Smoke Density Fire Tester
Maximum smoke density (MSD) and smoke density (SDR) for the specimen |
0-100% continuously measurable and automatically calculated |
With the standard optical correction error |
not more than 3%; each device is equipped with three standard filters, proof of light source data, representative |
Bunsen lamp working pressure |
(210 ± 5) KPa |
Bunsen lamp on the sample to impose a flame |
4min |
Automatic timing, automatic ignition, automatic smoke; luminous flux can be phased linear calibration test data more acurrate;
|
|
Touch Screen |
5 inch effective display size 11cm wide 6.28cm; b. Resolution: 800 * 480 |
communication interface |
RS232, 3.3V CMOS or TTL |
serial port d. storage capacity |
1G |
Gas source |
95% propane gas, or the same purity of the gas (customer-owned) |
boyut |
long * wide * high 740 * 500 * high 900 (mm) |
Fetures:
a. Size: 5 inch effective display size 11cm wide 6.28cm;
b. Resolution: 800 * 480
c. communication interface RS232, 3.3V CMOS or TTL, serial port
d. storage capacity: 1G
e. Using pure hardware FPGA driver display, "zero" start time, power can run
f. using M3 + FPGA architecture, M3 is responsible for instruction resolution, FPGA focus TFT display, speed and reliability are leading the same kind of program
g. The main controller uses low-power processor, automatically enter the energy-saving mode
Product parameters of the Smoke Density Fire Tester
yanan lamba | öğrencilerin ışık için, uzunluk 260 mm, nozul çapı 0.13mm, duman kutusu ile 45 ° açı; |
Fotoelektrik sistemi | lamba, güç 15W, işletim voltajı 6V için ışık kaynağı; |
Egzoz sistemi | Makine testinden sonra, egzoz deşarj açık olabilir, güçlü bir fan ile donatılmıştır; |
Duman yoğunluğu ölçüm aralığı | 0 ~% 100; |
Duman yoğunluğu ölçüm hassasiyeti | ±% 3; |
Alıcı | silikon fotovoltaik hücreler, içinden tamamen kılıfsız% 100 ışık ışık, ışık iletim hızı geçişi için% 0 ışık iletim oranı; |
Ana brülör çalışma basıncı | 276KPa (ayarlanabilir); |