SL-FL39 DIN 4102 Smoke Density Fire Tester
DIN 4102 مواد البناء القابلية للاشتعال اختبار المعدات / دخان الكثافة الفاحص النار
Product introduction of the Smoke Density Fire Tester
مناسبة تستخدم لقياس خاصية المنتجة للsomke من مواد البناء تحت شرط رقابة من الاحتراق أو التحلل، ويمكن أن تستخدم أيضا للمواد البلاستيكية الأخرى.
المعايير
ASTM D 2843، DIN 4102
Product Specification of the Smoke Density Fire Tester
Maximum smoke density (MSD) and smoke density (SDR) for the specimen |
0-100% continuously measurable and automatically calculated |
With the standard optical correction error |
not more than 3%; each device is equipped with three standard filters, proof of light source data, representative |
Bunsen lamp working pressure |
(210 ± 5) KPa |
Bunsen lamp on the sample to impose a flame |
4min |
Automatic timing, automatic ignition, automatic smoke; luminous flux can be phased linear calibration test data more acurrate;
|
|
Touch Screen |
5 inch effective display size 11cm wide 6.28cm; b. Resolution: 800 * 480 |
communication interface |
RS232, 3.3V CMOS or TTL |
serial port d. storage capacity |
1G |
Gas source |
95% propane gas, or the same purity of the gas (customer-owned) |
البعد |
long * wide * high 740 * 500 * high 900 (mm) |
Fetures:
a. Size: 5 inch effective display size 11cm wide 6.28cm;
b. Resolution: 800 * 480
c. communication interface RS232, 3.3V CMOS or TTL, serial port
d. storage capacity: 1G
e. Using pure hardware FPGA driver display, "zero" start time, power can run
f. using M3 + FPGA architecture, M3 is responsible for instruction resolution, FPGA focus TFT display, speed and reliability are leading the same kind of program
g. The main controller uses low-power processor, automatically enter the energy-saving mode
Product parameters of the Smoke Density Fire Tester
حرق مصباح | للطلاب ضوء، طول 260MM، فوهة قطرها 0.13mm، زاوية 45 درجة مع مربع الدخان، |
النظام الكهروضوئي | مصدر ضوء لمبة، والطاقة 15W، وتعمل 6V الجهد. |
نظام العادم | وقد تم تجهيز آلة مع مروحة قوية، بعد الاختبار، ويمكن أن يكون عادم الهواء الطلق فارغة. |
الدخان قياس مدى كثافة | 0 ~ 100٪؛ |
الدخان دقة قياس كثافة | ± 3٪، |
المتلقي | لخلايا السليكون الشمسية، ومعدل نقل الضوء من 0٪ لمرور الضوء معدل انتقال الضوء، الضوء 100٪ من دون غطاء تماما من خلال. |
الرئيسية ضغط الموقد العمل | 276KPa (قابل للتعديل)؛ |