SL-FL39 DIN 4102 Smoke Density Fire Tester
DIN 4102 Baustoffs Entflammbarkeit Prüfmaschinen / Rauchdichte Feuer Tester
Product introduction of the Smoke Density Fire Tester
Geeignet zum Messen der somke produzierenden verwendet Charakteristik des Materials unter kontrollierten Bedingungen von Verbrennungs Aufbau oder Zersetzung, und auch für andere Kunststoffe verwendet werden kann.
Standards
ASTM D 2843, DIN 4102
Product Specification of the Smoke Density Fire Tester
Maximum smoke density (MSD) and smoke density (SDR) for the specimen |
0-100% continuously measurable and automatically calculated |
With the standard optical correction error |
not more than 3%; each device is equipped with three standard filters, proof of light source data, representative |
Bunsen lamp working pressure |
(210 ± 5) KPa |
Bunsen lamp on the sample to impose a flame |
4min |
Automatic timing, automatic ignition, automatic smoke; luminous flux can be phased linear calibration test data more acurrate;
|
|
Touch Screen |
5 inch effective display size 11cm wide 6.28cm; b. Resolution: 800 * 480 |
communication interface |
RS232, 3.3V CMOS or TTL |
serial port d. storage capacity |
1G |
Gas source |
95% propane gas, or the same purity of the gas (customer-owned) |
Abmessungen |
long * wide * high 740 * 500 * high 900 (mm) |
Fetures:
a. Size: 5 inch effective display size 11cm wide 6.28cm;
b. Resolution: 800 * 480
c. communication interface RS232, 3.3V CMOS or TTL, serial port
d. storage capacity: 1G
e. Using pure hardware FPGA driver display, "zero" start time, power can run
f. using M3 + FPGA architecture, M3 is responsible for instruction resolution, FPGA focus TFT display, speed and reliability are leading the same kind of program
g. The main controller uses low-power processor, automatically enter the energy-saving mode
Product parameters of the Smoke Density Fire Tester
brennende Lampe | für die Schüler Licht, Länge 260 mm, Düsendurchmesser 0,13 mm, 45 ° Winkel mit der Rauchkammer; |
photoelektrischen System | Lichtquelle für die Lampe, 15 W Leistung, Betriebsspannung 6 V; |
Abgassystem | Die Maschine ist mit einem starken Ventilator, nach dem Test ausgestattet ist, kann das Abgas entladene draußen sein; |
Rauchdichte Meßbereichs | 0 ~ 100%; |
Rauchdichtemessgenauigkeit | ± 3%; |
Empfänger | für die Silizium-Solarzellen, Lichtdurchlässigkeit von 0% für den Durchgang von Licht, Lichtdurchlässigkeit von 100% Licht ohne Deckel vollständig durch; |
Hauptbrenner Arbeitsdruck | 276KPa (einstellbar); |