SL-FL39 DIN 4102 Smoke Density Fire Tester
DIN 4102 Eraikina Material FLAMMABILITY Entseguak Ekipamendua / Smoke dentsitatea Fire Tester
Product introduction of the Smoke Density Fire Tester
Egokia somke ekoizten eraikitzeko material errekuntza edo deskonposizio egoera kontrolatu pean, eta, gainera, ezaugarri neurtzeko erabiliko beste plastiko erabil daiteke.
Arauak
ASTM D 2843, DIN 4102
Product Specification of the Smoke Density Fire Tester
|
Maximum smoke density (MSD) and smoke density (SDR) for the specimen |
0-100% continuously measurable and automatically calculated |
|
With the standard optical correction error |
not more than 3%; each device is equipped with three standard filters, proof of light source data, representative |
|
Bunsen lamp working pressure |
(210 ± 5) KPa |
|
Bunsen lamp on the sample to impose a flame |
4min |
|
Automatic timing, automatic ignition, automatic smoke; luminous flux can be phased linear calibration test data more acurrate;
|
|
|
Touch Screen |
5 inch effective display size 11cm wide 6.28cm; b. Resolution: 800 * 480 |
|
communication interface |
RS232, 3.3V CMOS or TTL |
|
serial port d. storage capacity |
1G |
|
Gas source |
95% propane gas, or the same purity of the gas (customer-owned) |
|
Dimension |
long * wide * high 740 * 500 * high 900 (mm) |
Fetures:
a. Size: 5 inch effective display size 11cm wide 6.28cm;
b. Resolution: 800 * 480
c. communication interface RS232, 3.3V CMOS or TTL, serial port
d. storage capacity: 1G
e. Using pure hardware FPGA driver display, "zero" start time, power can run
f. using M3 + FPGA architecture, M3 is responsible for instruction resolution, FPGA focus TFT display, speed and reliability are leading the same kind of program
g. The main controller uses low-power processor, automatically enter the energy-saving mode
Product parameters of the Smoke Density Fire Tester
| Burning lanpara | ikasleen argia, luzera 260mm, pita diametroa 0.13mm, 45 º kea koadroan angelu; |
| fotovoltaiko sisteman | lanpara, power 15W, eragile tentsio 6V argi iturburu; |
| ihes-sistema | makina fan sendoa ditu, probaren ondoren, ihes botatako aire librean izan daiteke; |
| Smoke dentsitate neurketa sorta | 0 ~ 100%; |
| Smoke dentsitatea neurtzeko zehaztasun | ±% 3; |
| hargailuen | zelula silizio fotovoltaikoa, argi-transmisioa% 0 tasa argia, argi-transmisioa% 100 argi-tasa igarotzea estalki gabe erabat bidez egiteko; |
| Main erregailu lan-presioa | 276KPa (erregulagarria); |
