SL-FL39 DIN 4102 Smoke Density Fire Tester
DIN 4102 Rakennusmateriaalit Syttyvyys Testauslaitteet / savuntiheyden Tuli Tester
Product introduction of the Smoke Density Fire Tester
Sopivia mittauksessa käytettävä somke tuottavat ominaisuus rakennusmateriaali valvotuissa kunto palamisen tai hajoamisen, ja voidaan myös käyttää muut muovit.
Standardit
ASTM D 2843, DIN 4102
Product Specification of the Smoke Density Fire Tester
Maximum smoke density (MSD) and smoke density (SDR) for the specimen |
0-100% continuously measurable and automatically calculated |
With the standard optical correction error |
not more than 3%; each device is equipped with three standard filters, proof of light source data, representative |
Bunsen lamp working pressure |
(210 ± 5) KPa |
Bunsen lamp on the sample to impose a flame |
4min |
Automatic timing, automatic ignition, automatic smoke; luminous flux can be phased linear calibration test data more acurrate;
|
|
Touch Screen |
5 inch effective display size 11cm wide 6.28cm; b. Resolution: 800 * 480 |
communication interface |
RS232, 3.3V CMOS or TTL |
serial port d. storage capacity |
1G |
Gas source |
95% propane gas, or the same purity of the gas (customer-owned) |
Ulottuvuus |
long * wide * high 740 * 500 * high 900 (mm) |
Fetures:
a. Size: 5 inch effective display size 11cm wide 6.28cm;
b. Resolution: 800 * 480
c. communication interface RS232, 3.3V CMOS or TTL, serial port
d. storage capacity: 1G
e. Using pure hardware FPGA driver display, "zero" start time, power can run
f. using M3 + FPGA architecture, M3 is responsible for instruction resolution, FPGA focus TFT display, speed and reliability are leading the same kind of program
g. The main controller uses low-power processor, automatically enter the energy-saving mode
Product parameters of the Smoke Density Fire Tester
Lamppuöljyn | opiskelijoille valo, pituus 260mm, suuttimen halkaisija 0,13 mm, 45 ° kulmassa savun laatikko; |
valokennoja järjestelmä | valonlähde lampun teho 15W, käyttöjännite 6V; |
Pakoputkisto | kone on varustettu vahva tuuletin, testin jälkeen, pakokaasun voi olla tyhjä ulkona; |
Savun tiheys mittausalue | 0 ~ 100%; |
Savun tiheys mittaustarkkuus | ± 3%; |
Vastaanotin | piitä aurinkokennojen, valonläpäisevyys on 0% ja valon kulkua, valon siirtonopeus on 100% valoa ilman kantta täysin läpi; |
Pääpolttimen työpaine | 276KPa (säädettävä); |