SL-FL39 DIN 4102 Smoke Density Fire Tester
DIN 4102 građevnog materijala plamen Testing Equipment / dima Gustina Fire Tester
Product introduction of the Smoke Density Fire Tester
Pogodan za mjerenje karakteristika somke za proizvodnju građevinskog materijala pod kontrolisanim stanje sagorijevanja ili raspadanja, a može se koristiti i za druge plastike.
standardima
ASTM D 2843, DIN 4102
Product Specification of the Smoke Density Fire Tester
Maximum smoke density (MSD) and smoke density (SDR) for the specimen |
0-100% continuously measurable and automatically calculated |
With the standard optical correction error |
not more than 3%; each device is equipped with three standard filters, proof of light source data, representative |
Bunsen lamp working pressure |
(210 ± 5) KPa |
Bunsen lamp on the sample to impose a flame |
4min |
Automatic timing, automatic ignition, automatic smoke; luminous flux can be phased linear calibration test data more acurrate;
|
|
Touch Screen |
5 inch effective display size 11cm wide 6.28cm; b. Resolution: 800 * 480 |
communication interface |
RS232, 3.3V CMOS or TTL |
serial port d. storage capacity |
1G |
Gas source |
95% propane gas, or the same purity of the gas (customer-owned) |
dimenzija |
long * wide * high 740 * 500 * high 900 (mm) |
Fetures:
a. Size: 5 inch effective display size 11cm wide 6.28cm;
b. Resolution: 800 * 480
c. communication interface RS232, 3.3V CMOS or TTL, serial port
d. storage capacity: 1G
e. Using pure hardware FPGA driver display, "zero" start time, power can run
f. using M3 + FPGA architecture, M3 is responsible for instruction resolution, FPGA focus TFT display, speed and reliability are leading the same kind of program
g. The main controller uses low-power processor, automatically enter the energy-saving mode
Product parameters of the Smoke Density Fire Tester
Burning lampa | za studente zapali, dužina 260mm, mlaznica promjera 0.13mm, 45 ° ugao sa pušnica; |
fotoelektrični sistem | izvor svjetla za lampu, snaga 15W, radni napon 6V; |
izduvni sistem | stroj je opremljen sa snažnim ventilatorom, nakon testiranja, ispušni mogu biti otpuštene na otvorenom; |
Dim opseg mjerenja gustoće | 0 ~ 100%; |
Dim preciznost mjerenja gustoće | ± 3%; |
prijemnik | za silicij fotonaponskih ćelija, prenos svetlosti stopi od 0% za prolaz svjetlo, svjetlo prijenos stopi od 100% svjetlosti bez poklopca potpuno kroz; |
Glavni plamenik radni pritisak | 276KPa (podesivo); |