SL-FL39 DIN 4102 Smoke Density Fire Tester
DIN 4102 Bini Materjal Fjammabbiltà Ittestjar Tagħmir / Densità Duħħan nar Instron
Product introduction of the Smoke Density Fire Tester
Xieraq użat għall-kejl tal-karatteristika li jipproduċu somke ta 'materjal tal-bini taħt kondizzjoni kkontrollata ta' kombustjoni jew dekompożizzjoni, u wkoll jistgħu jintużaw għall-plastik oħra.
istandards
ASTM D 2843, DIN 4102
Product Specification of the Smoke Density Fire Tester
Maximum smoke density (MSD) and smoke density (SDR) for the specimen |
0-100% continuously measurable and automatically calculated |
With the standard optical correction error |
not more than 3%; each device is equipped with three standard filters, proof of light source data, representative |
Bunsen lamp working pressure |
(210 ± 5) KPa |
Bunsen lamp on the sample to impose a flame |
4min |
Automatic timing, automatic ignition, automatic smoke; luminous flux can be phased linear calibration test data more acurrate;
|
|
Touch Screen |
5 inch effective display size 11cm wide 6.28cm; b. Resolution: 800 * 480 |
communication interface |
RS232, 3.3V CMOS or TTL |
serial port d. storage capacity |
1G |
Gas source |
95% propane gas, or the same purity of the gas (customer-owned) |
dimensjoni |
long * wide * high 740 * 500 * high 900 (mm) |
Fetures:
a. Size: 5 inch effective display size 11cm wide 6.28cm;
b. Resolution: 800 * 480
c. communication interface RS232, 3.3V CMOS or TTL, serial port
d. storage capacity: 1G
e. Using pure hardware FPGA driver display, "zero" start time, power can run
f. using M3 + FPGA architecture, M3 is responsible for instruction resolution, FPGA focus TFT display, speed and reliability are leading the same kind of program
g. The main controller uses low-power processor, automatically enter the energy-saving mode
Product parameters of the Smoke Density Fire Tester
ħruq lampa | għall-istudenti dawl, 260mm tul, dijametru 0.13mm żennuna, 45 ° angolu mal-kaxxa duħħan; |
sistema fotoelettrika | sors ta 'dawl għall-fanal, l-enerġija 15W, li joperaw 6V vultaġġ; |
sistema ta 'exhaust | il-magna hija mgħammra bil-fann qawwija, wara t-test, il-egżost jista 'jkun mormija barra; |
Duħħan firxa kejl tad-densità | 0 ~ 100%; |
eżattezza kejl tad-densità tad-duħħan | ± 3%; |
riċevitur | għall-ċelluli fotovoltajċi silikon, dawl rata ta 'trażmissjoni ta' 0% għall-passaġġ ta 'dawl, rata ta' trażmissjoni tad-dawl ta 'dawl 100% mingħajr kopertura kompletament permezz; |
pressjoni tax-xogħol berner prinċipali | 276KPa (aġġustabbli); |