SL-FL39 DIN 4102 Smoke Density Fire Tester
DIN 4102 Materiale de constructii inflamabilitate Echipament de testare / fum Densitate Tester de foc
Product introduction of the Smoke Density Fire Tester
Adecvat utilizat pentru măsurarea caracteristicii producătoare de somke a materialului de construcție în condiții controlate de ardere sau de descompunere, și de asemenea, pot fi utilizate pentru alte materiale plastice.
Standarde
ASTM D 2843, DIN 4102
Product Specification of the Smoke Density Fire Tester
Maximum smoke density (MSD) and smoke density (SDR) for the specimen |
0-100% continuously measurable and automatically calculated |
With the standard optical correction error |
not more than 3%; each device is equipped with three standard filters, proof of light source data, representative |
Bunsen lamp working pressure |
(210 ± 5) KPa |
Bunsen lamp on the sample to impose a flame |
4min |
Automatic timing, automatic ignition, automatic smoke; luminous flux can be phased linear calibration test data more acurrate;
|
|
Touch Screen |
5 inch effective display size 11cm wide 6.28cm; b. Resolution: 800 * 480 |
communication interface |
RS232, 3.3V CMOS or TTL |
serial port d. storage capacity |
1G |
Gas source |
95% propane gas, or the same purity of the gas (customer-owned) |
Dimensiune |
long * wide * high 740 * 500 * high 900 (mm) |
Fetures:
a. Size: 5 inch effective display size 11cm wide 6.28cm;
b. Resolution: 800 * 480
c. communication interface RS232, 3.3V CMOS or TTL, serial port
d. storage capacity: 1G
e. Using pure hardware FPGA driver display, "zero" start time, power can run
f. using M3 + FPGA architecture, M3 is responsible for instruction resolution, FPGA focus TFT display, speed and reliability are leading the same kind of program
g. The main controller uses low-power processor, automatically enter the energy-saving mode
Product parameters of the Smoke Density Fire Tester
lampa de ardere | pentru studenții lumină, lungimea 260mm, duza diametru 0.13mm, unghi de 45 ° cu cutia de fum; |
sistemul fotoelectric | sursă de lumină pentru lampa, putere 15W, care funcționează 6V de tensiune; |
Sistem de evacuare | mașina este echipată cu un ventilator puternic, după test, de evacuare poate fi în aer liber externați; |
Fum Interval de măsurare a densității | 0 ~ 100%; |
Precizia de măsurare a densității fumului | ± 3%; |
Receptor | pentru celulele fotovoltaice siliciu, rata de transmisie a luminii de la 0% pentru trecerea ratei de transmisie a luminii, lumina de 100% lumină fără capac complet prin; |
Presiune de lucru arzător principal | 276KPa (reglabil); |