SL-FL39 DIN 4102 Smoke Density Fire Tester
Din 4102 Building Material inflamabilidad Testing Equipment / Fumo Denseco Fajro Tester
Product introduction of the Smoke Density Fire Tester
Taŭga uzita por mezuri la somke produktantoj karakterizaĵon de konstruado materialoj sub kontrolitaj kondiĉo de brulado aŭ putriĝo, kaj ankaŭ povas esti uzata por aliaj plastoj.
normoj
ASTM D 2843, DIN 4102
Product Specification of the Smoke Density Fire Tester
Maximum smoke density (MSD) and smoke density (SDR) for the specimen |
0-100% continuously measurable and automatically calculated |
With the standard optical correction error |
not more than 3%; each device is equipped with three standard filters, proof of light source data, representative |
Bunsen lamp working pressure |
(210 ± 5) KPa |
Bunsen lamp on the sample to impose a flame |
4min |
Automatic timing, automatic ignition, automatic smoke; luminous flux can be phased linear calibration test data more acurrate;
|
|
Touch Screen |
5 inch effective display size 11cm wide 6.28cm; b. Resolution: 800 * 480 |
communication interface |
RS232, 3.3V CMOS or TTL |
serial port d. storage capacity |
1G |
Gas source |
95% propane gas, or the same purity of the gas (customer-owned) |
dimensio |
long * wide * high 740 * 500 * high 900 (mm) |
Fetures:
a. Size: 5 inch effective display size 11cm wide 6.28cm;
b. Resolution: 800 * 480
c. communication interface RS232, 3.3V CMOS or TTL, serial port
d. storage capacity: 1G
e. Using pure hardware FPGA driver display, "zero" start time, power can run
f. using M3 + FPGA architecture, M3 is responsible for instruction resolution, FPGA focus TFT display, speed and reliability are leading the same kind of program
g. The main controller uses low-power processor, automatically enter the energy-saving mode
Product parameters of the Smoke Density Fire Tester
flamo | por la studentoj lumo, longeco 260mm, cigaredingo diametron 0.13mm, 45 ° angulo kun la fumo skatolo; |
fotoeléctrico sistemo | lumfonto por la lampo, potenco 15W, operaciante tensio 6v; |
sistemo de ellasilo | la maŝino estas ekipita per granda ventumilo, post la testo, la ellasilo povas esti eligita al la libera aero; |
Fumo denseco mezurado gamo | 0 ~ 100%; |
Fumo denseco mezurado precizeco | ± 3%; |
ricevilo | por la silicio fotovoltaicas ĉeloj, malpeza transdono rapideco de 0% por la paŝo de lumo, lumo transdono rapideco de 100% lumo sen kovrilo tute tra; |
Ĉefa brulilo laborista premo | 276KPa (ajustable); |