SL-FL39 DIN 4102 Smoke Density Fire Tester
DIN 4102 Stavebný materiál horľavosti Skúšobné vybavenie / Smoke Hustota Fire Tester
Product introduction of the Smoke Density Fire Tester
Vhodné používa na meranie somke produkujúce charakteristiku stavebného materiálu za kontrolované podmienky spaľovania alebo rozkladu, a tiež môžu byť použité na iné plasty.
štandardy
ASTM D 2843, DIN 4102
Product Specification of the Smoke Density Fire Tester
Maximum smoke density (MSD) and smoke density (SDR) for the specimen |
0-100% continuously measurable and automatically calculated |
With the standard optical correction error |
not more than 3%; each device is equipped with three standard filters, proof of light source data, representative |
Bunsen lamp working pressure |
(210 ± 5) KPa |
Bunsen lamp on the sample to impose a flame |
4min |
Automatic timing, automatic ignition, automatic smoke; luminous flux can be phased linear calibration test data more acurrate;
|
|
Touch Screen |
5 inch effective display size 11cm wide 6.28cm; b. Resolution: 800 * 480 |
communication interface |
RS232, 3.3V CMOS or TTL |
serial port d. storage capacity |
1G |
Gas source |
95% propane gas, or the same purity of the gas (customer-owned) |
rozmer |
long * wide * high 740 * 500 * high 900 (mm) |
Fetures:
a. Size: 5 inch effective display size 11cm wide 6.28cm;
b. Resolution: 800 * 480
c. communication interface RS232, 3.3V CMOS or TTL, serial port
d. storage capacity: 1G
e. Using pure hardware FPGA driver display, "zero" start time, power can run
f. using M3 + FPGA architecture, M3 is responsible for instruction resolution, FPGA focus TFT display, speed and reliability are leading the same kind of program
g. The main controller uses low-power processor, automatically enter the energy-saving mode
Product parameters of the Smoke Density Fire Tester
horiace lampa | Pre študentov svetlo, dĺžka 260 mm, priemer trysky 0,13 mm, pod uhlom 45 ° s udiarne; |
fotoelektrický systém | zdroj svetla lampy, výkonu 15 W, prevádzkové napätie 6V; |
Výfukový systém | Stroj je vybavený silným ventilátorom, po skúške, výfukový môžu byť odvádzané von; |
Dym rozsah merania hustoty | 0 ~ 100%; |
Dym Presnosť merania hustoty | ± 3%; |
prijímač | pre kremík fotovoltaické články, ľahké prenosové rýchlosti 0% pre priechod svetla, svetla prenosovou rýchlosťou 100% svetla bez krytu úplne skrz; |
Hlavný pracovný tlak horáka | 276KPa (nastaviteľná); |