SL-FL39 DIN 4102 Smoke Density Fire Tester
DIN 4102 Gedong Bahan Flammability Tés Equipment / Haseup Density Seuneu tester
Product introduction of the Smoke Density Fire Tester
Cocog dipaké pikeun ngukur ciri somke-ngahasilkeun bahan ngawangun kaayaan kondisi dikawasa tina durukan atanapi dékomposisi, sarta ogé bisa dipaké pikeun plastik lianna.
standar
ASTM D 2843, DIN 4102
Product Specification of the Smoke Density Fire Tester
|
Maximum smoke density (MSD) and smoke density (SDR) for the specimen |
0-100% continuously measurable and automatically calculated |
|
With the standard optical correction error |
not more than 3%; each device is equipped with three standard filters, proof of light source data, representative |
|
Bunsen lamp working pressure |
(210 ± 5) KPa |
|
Bunsen lamp on the sample to impose a flame |
4min |
|
Automatic timing, automatic ignition, automatic smoke; luminous flux can be phased linear calibration test data more acurrate;
|
|
|
Touch Screen |
5 inch effective display size 11cm wide 6.28cm; b. Resolution: 800 * 480 |
|
communication interface |
RS232, 3.3V CMOS or TTL |
|
serial port d. storage capacity |
1G |
|
Gas source |
95% propane gas, or the same purity of the gas (customer-owned) |
|
ukuran |
long * wide * high 740 * 500 * high 900 (mm) |
Fetures:
a. Size: 5 inch effective display size 11cm wide 6.28cm;
b. Resolution: 800 * 480
c. communication interface RS232, 3.3V CMOS or TTL, serial port
d. storage capacity: 1G
e. Using pure hardware FPGA driver display, "zero" start time, power can run
f. using M3 + FPGA architecture, M3 is responsible for instruction resolution, FPGA focus TFT display, speed and reliability are leading the same kind of program
g. The main controller uses low-power processor, automatically enter the energy-saving mode
Product parameters of the Smoke Density Fire Tester
| lampu ngaduruk | pikeun siswa terang, panjangna 260mm, nozzle diaméterna 0.13mm, 45 ° sudut kalayan kotak haseup; |
| sistim Photoelectric | Sumber lampu pikeun lampu, kakuatan 15W, tegangan operasi 6V; |
| sistim haseup | mesin geus dilengkepan kipas kuat, sanggeus tes, haseup bisa ker discharged; |
| Haseup rentang ukur dénsitas | 0 ~ 100%; |
| Haseup akurasi ukur dénsitas | ± 3%; |
| panarima | pikeun sél silikon photovoltaic, laju pangiriman lampu tina 0% keur petikan lampu laju pangiriman, cahya lampu 100% tanpa panutup lengkep ngaliwatan; |
| tekanan burner kerja Utama | 276KPa (adjustable); |
