SL-FL39 DIN 4102 Smoke Density Fire Tester
DIN 4102 boumateriaal Brandbestandheid Toets Toerusting / Rook Digtheid Vuur Tester
Product introduction of the Smoke Density Fire Tester
Geskikte gebruik vir die meet van die somke vervaardiging kenmerkend van boumateriaal onder gekontroleerde toestand van verbranding of ontbinding, en kan ook gebruik word vir ander plastiek.
standaarde
ASTM D 2843, DIN 4102
Product Specification of the Smoke Density Fire Tester
Maximum smoke density (MSD) and smoke density (SDR) for the specimen |
0-100% continuously measurable and automatically calculated |
With the standard optical correction error |
not more than 3%; each device is equipped with three standard filters, proof of light source data, representative |
Bunsen lamp working pressure |
(210 ± 5) KPa |
Bunsen lamp on the sample to impose a flame |
4min |
Automatic timing, automatic ignition, automatic smoke; luminous flux can be phased linear calibration test data more acurrate;
|
|
Touch Screen |
5 inch effective display size 11cm wide 6.28cm; b. Resolution: 800 * 480 |
communication interface |
RS232, 3.3V CMOS or TTL |
serial port d. storage capacity |
1G |
Gas source |
95% propane gas, or the same purity of the gas (customer-owned) |
dimensie |
long * wide * high 740 * 500 * high 900 (mm) |
Fetures:
a. Size: 5 inch effective display size 11cm wide 6.28cm;
b. Resolution: 800 * 480
c. communication interface RS232, 3.3V CMOS or TTL, serial port
d. storage capacity: 1G
e. Using pure hardware FPGA driver display, "zero" start time, power can run
f. using M3 + FPGA architecture, M3 is responsible for instruction resolution, FPGA focus TFT display, speed and reliability are leading the same kind of program
g. The main controller uses low-power processor, automatically enter the energy-saving mode
Product parameters of the Smoke Density Fire Tester
brandende lamp | vir die studente aan die lig, lengte 260mm, mondstuk deursnee 0.13mm, 45 ° hoek met die rook boks; |
foto-elektriese stelsel | ligbron vir die lamp, krag 15W, bedryfstelsel spanning 6V; |
Uitlaatstelsel | die masjien is toegerus met 'n sterk fan, nadat die toets, kan die uitlaat ontslaan buitelug; |
Rook meting digtheid reeks | 0 ~ 100%; |
Rook meting digtheid akkuraatheid | ± 3%; |
ontvanger | vir die silikon fotovoltaïese selle, lig transmissie tempo van 0% vir die verloop van die lig, lig transmissie tempo van 100% lig sonder dekking heeltemal deur; |
Main brander werkdruk | 276KPa (verstelbaar); |