SL-FL39 DIN 4102 Smoke Density Fire Tester
ДИН 4102 грађевинског материјала на пламен Опрема за тестирање / дима Густина пожара тестер
Product introduction of the Smoke Density Fire Tester
Погодан користи за мерење карактеристика грађевинског материјала под контролисаним условима сагоревања или разлагања, а такође сомке производњу могу се користити за друге пластике.
standardi
АСТМ Д 2843, ДИН 4102
Product Specification of the Smoke Density Fire Tester
Maximum smoke density (MSD) and smoke density (SDR) for the specimen |
0-100% continuously measurable and automatically calculated |
With the standard optical correction error |
not more than 3%; each device is equipped with three standard filters, proof of light source data, representative |
Bunsen lamp working pressure |
(210 ± 5) KPa |
Bunsen lamp on the sample to impose a flame |
4min |
Automatic timing, automatic ignition, automatic smoke; luminous flux can be phased linear calibration test data more acurrate;
|
|
Touch Screen |
5 inch effective display size 11cm wide 6.28cm; b. Resolution: 800 * 480 |
communication interface |
RS232, 3.3V CMOS or TTL |
serial port d. storage capacity |
1G |
Gas source |
95% propane gas, or the same purity of the gas (customer-owned) |
Димензија |
long * wide * high 740 * 500 * high 900 (mm) |
Fetures:
a. Size: 5 inch effective display size 11cm wide 6.28cm;
b. Resolution: 800 * 480
c. communication interface RS232, 3.3V CMOS or TTL, serial port
d. storage capacity: 1G
e. Using pure hardware FPGA driver display, "zero" start time, power can run
f. using M3 + FPGA architecture, M3 is responsible for instruction resolution, FPGA focus TFT display, speed and reliability are leading the same kind of program
g. The main controller uses low-power processor, automatically enter the energy-saving mode
Product parameters of the Smoke Density Fire Tester
Бурнинг лампа | за студенти светло, дужина 260мм, млазница пречник 0.13мм, 45 ° угао са пушница; |
фотоелектрични систем | извор светлости за лампу, снаге 15В, радни напон 6В; |
Издувни систем | машина је опремљена са јаким вентилатором, након теста, издувни може бити отпуштен на отвореном; |
Смоке мерења густине ранге | 0 ~ 100%; |
Дим прецизност мерења густине | ± 3%; |
пријемник | за силицијум фотонапонских ћелија, светло преноса стопи од 0% за пролазак светлости, светлости преноса стопи од 100% светлости без поклопца кроз цео процес; |
Главни горионик радни притисак | 276КПа (адјустабле); |