SL-FL39 DIN 4102 Smoke Density Fire Tester
DIN 4102 градежен материјал Запаливост тестирање Опрема / Густина на чад пожар тестер
Product introduction of the Smoke Density Fire Tester
Погодно користи за мерење на somke производство карактеристика на градежен материјал под контролирани услови на согорување или распаѓање, а исто така може да се користи за други видови пластика.
стандарди
ASTM D 2843, DIN 4102
Product Specification of the Smoke Density Fire Tester
Maximum smoke density (MSD) and smoke density (SDR) for the specimen |
0-100% continuously measurable and automatically calculated |
With the standard optical correction error |
not more than 3%; each device is equipped with three standard filters, proof of light source data, representative |
Bunsen lamp working pressure |
(210 ± 5) KPa |
Bunsen lamp on the sample to impose a flame |
4min |
Automatic timing, automatic ignition, automatic smoke; luminous flux can be phased linear calibration test data more acurrate;
|
|
Touch Screen |
5 inch effective display size 11cm wide 6.28cm; b. Resolution: 800 * 480 |
communication interface |
RS232, 3.3V CMOS or TTL |
serial port d. storage capacity |
1G |
Gas source |
95% propane gas, or the same purity of the gas (customer-owned) |
димензија |
long * wide * high 740 * 500 * high 900 (mm) |
Fetures:
a. Size: 5 inch effective display size 11cm wide 6.28cm;
b. Resolution: 800 * 480
c. communication interface RS232, 3.3V CMOS or TTL, serial port
d. storage capacity: 1G
e. Using pure hardware FPGA driver display, "zero" start time, power can run
f. using M3 + FPGA architecture, M3 is responsible for instruction resolution, FPGA focus TFT display, speed and reliability are leading the same kind of program
g. The main controller uses low-power processor, automatically enter the energy-saving mode
Product parameters of the Smoke Density Fire Tester
гори светилка | за студентите светлина, должина 260mm, прскалка дијаметар 0.13mm, 45 ° агол со полето на чад; |
фотоелектричен систем | извор на светлина за светилка, моќ 15W, работен напон 6V; |
системот за издувни гасови | машина е опремена со силна вентилатор, по завршувањето на тестот, издувните гасови може да биде разрешен на отворено; |
На чад мерен опсег густина | 0 ~ 100%; |
На чад точност на мерење густина | ± 3%; |
приемник | за силикон фотоволтаични клетки, пренос на светлината стапка од 0% за премин на светлина, пренос на светлината стапка од 100% светлина без капак целосно преку; |
Главната режач работен притисок | 276KPa (со прилагодување); |