SL-FL39 DIN 4102 Smoke Density Fire Tester
DIN 4102 건축 자재 난연성 시험 장비 / 연기 밀도 화재 테스터
Product introduction of the Smoke Density Fire Tester
또한 연소 또는 분해 조절 조건 건재 및 somke의 생산 특성을 측정하는데 적합한 다른 플라스틱을 사용할 수있다.
기준
ASTM D 2843, 4102 DIN
Product Specification of the Smoke Density Fire Tester
Maximum smoke density (MSD) and smoke density (SDR) for the specimen |
0-100% continuously measurable and automatically calculated |
With the standard optical correction error |
not more than 3%; each device is equipped with three standard filters, proof of light source data, representative |
Bunsen lamp working pressure |
(210 ± 5) KPa |
Bunsen lamp on the sample to impose a flame |
4min |
Automatic timing, automatic ignition, automatic smoke; luminous flux can be phased linear calibration test data more acurrate;
|
|
Touch Screen |
5 inch effective display size 11cm wide 6.28cm; b. Resolution: 800 * 480 |
communication interface |
RS232, 3.3V CMOS or TTL |
serial port d. storage capacity |
1G |
Gas source |
95% propane gas, or the same purity of the gas (customer-owned) |
치수 |
long * wide * high 740 * 500 * high 900 (mm) |
Fetures:
a. Size: 5 inch effective display size 11cm wide 6.28cm;
b. Resolution: 800 * 480
c. communication interface RS232, 3.3V CMOS or TTL, serial port
d. storage capacity: 1G
e. Using pure hardware FPGA driver display, "zero" start time, power can run
f. using M3 + FPGA architecture, M3 is responsible for instruction resolution, FPGA focus TFT display, speed and reliability are leading the same kind of program
g. The main controller uses low-power processor, automatically enter the energy-saving mode
Product parameters of the Smoke Density Fire Tester
불타는 램프 | 학생들은 빛, 길이 260mm, 노즐 직경 0.13mm의 연실 45 ° 각도; |
광전 시스템 | 램프 전력 15W, 작동 전압 6V위한 광원; |
배기 시스템 | 시스템이 시험 후, 배기 배출 도어 일 수 강한 팬 장착되고 |
연기 밀도 측정 범위 | 0 ~ 100 %; |
연기 밀도 측정 정확도 | ± 3 %; |
리시버 | 실리콘 태양 전지, 커버를 완전히 관통하지 않고 100 %의 광의, 광 투과도의 통로 0 %의 광 투과율에 대한; |
메인 버너 작동 압력 | 276KPa (조절); |