SL-FL39 DIN 4102 Smoke Density Fire Tester
DIN 4102 Bouwmateriaal Ontvlambaarheid Testapparatuur / Smoke Density Fire Tester
Product introduction of the Smoke Density Fire Tester
Geschikt voor het meten van de somke producerende eigenschap bouwmateriaal onder gecontroleerde voorwaarde verbranding of ontbinding, en kan ook worden gebruikt voor andere kunststoffen.
normen
ASTM D 2843, DIN 4102
Product Specification of the Smoke Density Fire Tester
Maximum smoke density (MSD) and smoke density (SDR) for the specimen |
0-100% continuously measurable and automatically calculated |
With the standard optical correction error |
not more than 3%; each device is equipped with three standard filters, proof of light source data, representative |
Bunsen lamp working pressure |
(210 ± 5) KPa |
Bunsen lamp on the sample to impose a flame |
4min |
Automatic timing, automatic ignition, automatic smoke; luminous flux can be phased linear calibration test data more acurrate;
|
|
Touch Screen |
5 inch effective display size 11cm wide 6.28cm; b. Resolution: 800 * 480 |
communication interface |
RS232, 3.3V CMOS or TTL |
serial port d. storage capacity |
1G |
Gas source |
95% propane gas, or the same purity of the gas (customer-owned) |
Dimensie |
long * wide * high 740 * 500 * high 900 (mm) |
Fetures:
a. Size: 5 inch effective display size 11cm wide 6.28cm;
b. Resolution: 800 * 480
c. communication interface RS232, 3.3V CMOS or TTL, serial port
d. storage capacity: 1G
e. Using pure hardware FPGA driver display, "zero" start time, power can run
f. using M3 + FPGA architecture, M3 is responsible for instruction resolution, FPGA focus TFT display, speed and reliability are leading the same kind of program
g. The main controller uses low-power processor, automatically enter the energy-saving mode
Product parameters of the Smoke Density Fire Tester
brandende lamp | voor studenten licht, lengte 260 mm, mondstukdiameter 0,13 mm, 45 ° hoek met de rookafvoer; |
foto-elektrische systeem | lichtbron van de lamp 15W vermogen, bedrijfsspanning 6V; |
Uitlaatsysteem | de machine is voorzien van een krachtige ventilator, na de test, kan de uitlaat worden ontladen buiten; |
Opaciteitsmeet- dichtheidbereik | 0 -100%; |
Rook dichtheidsmeting nauwkeurigheid | ± 3%; |
Ontvanger | voor het silicium fotovoltaïsche cellen, lichttransmissie van 0% voor de passage van licht, licht overdrachtssnelheid van 100% licht zonder deksel volledig door; |
Hoofdbrander werkdruk | 276KPa (instelbaar); |