SL-FL39 DIN 4102 Smoke Density Fire Tester
DIN 4102建築材料燃焼性試験装置/煙濃度火テスター
Product introduction of the Smoke Density Fire Tester
適切な燃焼又は分解の制御された条件の下で材料を構築するとともに、他のプラスチックに使用することができるのsomke産生特性を測定するために使用されます。
規格
ASTM D 2843、4102 DIN
Product Specification of the Smoke Density Fire Tester
Maximum smoke density (MSD) and smoke density (SDR) for the specimen |
0-100% continuously measurable and automatically calculated |
With the standard optical correction error |
not more than 3%; each device is equipped with three standard filters, proof of light source data, representative |
Bunsen lamp working pressure |
(210 ± 5) KPa |
Bunsen lamp on the sample to impose a flame |
4min |
Automatic timing, automatic ignition, automatic smoke; luminous flux can be phased linear calibration test data more acurrate;
|
|
Touch Screen |
5 inch effective display size 11cm wide 6.28cm; b. Resolution: 800 * 480 |
communication interface |
RS232, 3.3V CMOS or TTL |
serial port d. storage capacity |
1G |
Gas source |
95% propane gas, or the same purity of the gas (customer-owned) |
寸法 |
long * wide * high 740 * 500 * high 900 (mm) |
Fetures:
a. Size: 5 inch effective display size 11cm wide 6.28cm;
b. Resolution: 800 * 480
c. communication interface RS232, 3.3V CMOS or TTL, serial port
d. storage capacity: 1G
e. Using pure hardware FPGA driver display, "zero" start time, power can run
f. using M3 + FPGA architecture, M3 is responsible for instruction resolution, FPGA focus TFT display, speed and reliability are leading the same kind of program
g. The main controller uses low-power processor, automatically enter the energy-saving mode
Product parameters of the Smoke Density Fire Tester
バーニングランプ | 学生は光に対して、長さ260ミリメートル、ノズル直径0.13ミリメートル、煙ボックスと45°の角度。 |
光電システム | ランプ用光源、パワー15W、動作電圧6V。 |
排気システム | 機械は試験後、排気を排出屋外であることができる、強力なファンを備えています。 |
煙濃度測定範囲 | 0〜100%; |
煙濃度測定精度 | ±3%。 |
受信機 | 完全スルーシリコン太陽電池、光の通過のための0%の光透過率、カバーなしで100%の光の光透過率がために、 |
メインバーナの使用圧力 | 276KPa(調節可能)。 |