SL-FL39 DIN 4102 Smoke Density Fire Tester
DIN 4102 Շինանյութ Flammability Testing Equipment / Smoke խտության Կրակ Tester
Product introduction of the Smoke Density Fire Tester
Հարմար օգտագործվում է չափման somke արտադրող բնորոշ շինանյութի տակ վերահսկվող պայմանով այրման կամ քայքայմամբ, ինչպես նաեւ կարող է օգտագործվել այլ պլաստմասսայի.
չափանիշները
ASTM D 2843, DIN 4102
Product Specification of the Smoke Density Fire Tester
Maximum smoke density (MSD) and smoke density (SDR) for the specimen |
0-100% continuously measurable and automatically calculated |
With the standard optical correction error |
not more than 3%; each device is equipped with three standard filters, proof of light source data, representative |
Bunsen lamp working pressure |
(210 ± 5) KPa |
Bunsen lamp on the sample to impose a flame |
4min |
Automatic timing, automatic ignition, automatic smoke; luminous flux can be phased linear calibration test data more acurrate;
|
|
Touch Screen |
5 inch effective display size 11cm wide 6.28cm; b. Resolution: 800 * 480 |
communication interface |
RS232, 3.3V CMOS or TTL |
serial port d. storage capacity |
1G |
Gas source |
95% propane gas, or the same purity of the gas (customer-owned) |
չափ |
long * wide * high 740 * 500 * high 900 (mm) |
Fetures:
a. Size: 5 inch effective display size 11cm wide 6.28cm;
b. Resolution: 800 * 480
c. communication interface RS232, 3.3V CMOS or TTL, serial port
d. storage capacity: 1G
e. Using pure hardware FPGA driver display, "zero" start time, power can run
f. using M3 + FPGA architecture, M3 is responsible for instruction resolution, FPGA focus TFT display, speed and reliability are leading the same kind of program
g. The main controller uses low-power processor, automatically enter the energy-saving mode
Product parameters of the Smoke Density Fire Tester
այրվում ճրագ | ուսանողների համար լուսավորեն, երկարությունը 260mm, վարդակ տրամագիծը 0.13mm, 45 ° անկյան տակ, ինչպես նաեւ ծխի վանդակում. |
photoelectric համակարգ | լույսի աղբյուր է լամպի, իշխանության 15W, գործում լարման 6V. |
Օդափոխման համակարգ | մեքենան հագեցած է հզոր երկրպագու, հետո քննության, ապա սպառել կարող է գրվել դրսում. |
Ծուխը խտությունը չափման միջակայք | 0 ~ 100%; |
Ծուխը խտությունը չափման ճշտությունը | ± 3%. |
ընդունիչ | համար սիլիկոնային ֆոտոգալվանային բջիջների, թեթեւ փոխանցման արագությունը 0% ընդունումը թեթեւ, թեթեւ փոխանցման 100% լույսի առանց ծածկույթի բոլորովին միջոցով. |
Գլխավոր այրիչ աշխատանքային ճնշումը | 276KPa (շարժական): |