SL-FL39 DIN 4102 Smoke Density Fire Tester
دين 4102 د ودانیزو توکو د آزموینې او انفلاق تجهیزات / دود: دبوټو اور ټسټ
Product introduction of the Smoke Density Fire Tester
مناسب د احتراق يا تجزيه کنټرول حالت لاندې موادو د جوړولو، او هم د somke د تولید ځانګړتیا د اندازه کولو لپاره کارول کولای شي د نورو پلاستیک وکارول شي.
د ستندرد
ASTM D 2843، دين 4102
Product Specification of the Smoke Density Fire Tester
Maximum smoke density (MSD) and smoke density (SDR) for the specimen |
0-100% continuously measurable and automatically calculated |
With the standard optical correction error |
not more than 3%; each device is equipped with three standard filters, proof of light source data, representative |
Bunsen lamp working pressure |
(210 ± 5) KPa |
Bunsen lamp on the sample to impose a flame |
4min |
Automatic timing, automatic ignition, automatic smoke; luminous flux can be phased linear calibration test data more acurrate;
|
|
Touch Screen |
5 inch effective display size 11cm wide 6.28cm; b. Resolution: 800 * 480 |
communication interface |
RS232, 3.3V CMOS or TTL |
serial port d. storage capacity |
1G |
Gas source |
95% propane gas, or the same purity of the gas (customer-owned) |
بعدونه |
long * wide * high 740 * 500 * high 900 (mm) |
Fetures:
a. Size: 5 inch effective display size 11cm wide 6.28cm;
b. Resolution: 800 * 480
c. communication interface RS232, 3.3V CMOS or TTL, serial port
d. storage capacity: 1G
e. Using pure hardware FPGA driver display, "zero" start time, power can run
f. using M3 + FPGA architecture, M3 is responsible for instruction resolution, FPGA focus TFT display, speed and reliability are leading the same kind of program
g. The main controller uses low-power processor, automatically enter the energy-saving mode
Product parameters of the Smoke Density Fire Tester
د سوځولو څراغ | د زده کوونکو د روښانه، په اوږدوالي د 260mm، نلۍ قطر 0.13mm، 45 ° سره د لوګي په بکس زاويه؛ |
Photoelectric سیستم | د څراغ، د برېښنا د 15W، ولتاژ 6V فعالیت د رڼا سرچينه؛ |
لوګي د سیسټم | د ماشین سره په یوه قوي مينه سمبال، د دې ازموينې وروسته، د لوګی شي رخصت تر خيمو لاندې؛ |
دود غلظت اندازه لړ | 0 ~ 100٪؛ |
دود غلظت اندازه د دقت | ± 3٪؛ |
د اخيستونکي | د سیلیکون د بطريو د حجرو، د پوښ پرته د رڼا، د 100٪ رڼا رڼا د لېږد کچه له لارې په بشپړه توګه تیریدلو لپاره د 0٪ د رڼا د لېږد کچه؛ |
اصلي بلونې کاري فشار | 276KPa (تعدیل)؛ |