SL-FL39 DIN 4102 Smoke Density Fire Tester
Aedificium edificium (IV)CII Signa Lorem Equipment silicium Material / Tester ascenderet fumus ignis CRASSITUDO
Product introduction of the Smoke Density Fire Tester
Idoneam ad usus somke mensuræ in producendo, de ratione materiae est sub conditione, coerceri vel compositione combustionis est, et quoque potest esse alia plastics.
Signa
ASTM D MMDCCCXLIII: Signa (IV)CII
Product Specification of the Smoke Density Fire Tester
|
Maximum smoke density (MSD) and smoke density (SDR) for the specimen |
0-100% continuously measurable and automatically calculated |
|
With the standard optical correction error |
not more than 3%; each device is equipped with three standard filters, proof of light source data, representative |
|
Bunsen lamp working pressure |
(210 ± 5) KPa |
|
Bunsen lamp on the sample to impose a flame |
4min |
|
Automatic timing, automatic ignition, automatic smoke; luminous flux can be phased linear calibration test data more acurrate;
|
|
|
Touch Screen |
5 inch effective display size 11cm wide 6.28cm; b. Resolution: 800 * 480 |
|
communication interface |
RS232, 3.3V CMOS or TTL |
|
serial port d. storage capacity |
1G |
|
Gas source |
95% propane gas, or the same purity of the gas (customer-owned) |
|
ratio |
long * wide * high 740 * 500 * high 900 (mm) |
Fetures:
a. Size: 5 inch effective display size 11cm wide 6.28cm;
b. Resolution: 800 * 480
c. communication interface RS232, 3.3V CMOS or TTL, serial port
d. storage capacity: 1G
e. Using pure hardware FPGA driver display, "zero" start time, power can run
f. using M3 + FPGA architecture, M3 is responsible for instruction resolution, FPGA focus TFT display, speed and reliability are leading the same kind of program
g. The main controller uses low-power processor, automatically enter the energy-saving mode
Product parameters of the Smoke Density Fire Tester
| lucerna Estuans | lux enim alumni, longitudo 260mm, COLLUM diam 0.13mm, XLV ° angulus fumo lucem capsa; |
| ratio photoelectric | lux source pro lucerna, potentia 15W, voltage operating 6 V; |
| ratio exhauriunt | apparatus instructa fortis ventilabro in experimentum potest dimitti exhauriunt foris; |
| Ascendit fumus density range measurement | * C% 0; |
| Ascendit fumus density measurement accuracy | ± III%; |
| receptor | Silicon photovoltaic ad cellas, lux tradenda 0% rate of facilis enim itus ab lux, lux lucem facilioris Transmissus rate de C% non omnino per operculum; |
| USTOR principalis pressura working | 276KPa (vocabulary); |
