SL-FL39 DIN 4102 Smoke Density Fire Tester
Olowalu 4102 Building Material Flammability ikea ai lako a / Pukoa ae nuʻa noʻia
Product introduction of the Smoke Density Fire Tester
Kupono hoʻohana 'ia no ka ana i ka somke-hua ano o ke kūkuluʻana i nā puke ma lalo o kekahi lāʻau' ano o ka'ā a me decomposition, a hoi hiki ke hoʻohana 'ia no nā lula ea.
Standards
ASTM D 2843, olowalu 4102
Product Specification of the Smoke Density Fire Tester
Maximum smoke density (MSD) and smoke density (SDR) for the specimen |
0-100% continuously measurable and automatically calculated |
With the standard optical correction error |
not more than 3%; each device is equipped with three standard filters, proof of light source data, representative |
Bunsen lamp working pressure |
(210 ± 5) KPa |
Bunsen lamp on the sample to impose a flame |
4min |
Automatic timing, automatic ignition, automatic smoke; luminous flux can be phased linear calibration test data more acurrate;
|
|
Touch Screen |
5 inch effective display size 11cm wide 6.28cm; b. Resolution: 800 * 480 |
communication interface |
RS232, 3.3V CMOS or TTL |
serial port d. storage capacity |
1G |
Gas source |
95% propane gas, or the same purity of the gas (customer-owned) |
Ana |
long * wide * high 740 * 500 * high 900 (mm) |
Fetures:
a. Size: 5 inch effective display size 11cm wide 6.28cm;
b. Resolution: 800 * 480
c. communication interface RS232, 3.3V CMOS or TTL, serial port
d. storage capacity: 1G
e. Using pure hardware FPGA driver display, "zero" start time, power can run
f. using M3 + FPGA architecture, M3 is responsible for instruction resolution, FPGA focus TFT display, speed and reliability are leading the same kind of program
g. The main controller uses low-power processor, automatically enter the energy-saving mode
Product parameters of the Smoke Density Fire Tester
ke ahi kukui | no ka haumāna ho'ā, lōʻihi 260mm, kīʻamo anawaena 0.13mm, 45 ° huina me ka uahi pahu; |
Photoelectric kahua | ke kukui no ka ipukukui, mana 15W, ke hoʻohana anakahi uila 6V; |
a no ka maluhiluhi kahua | ka mīkini ua lako pono me ka peahi ikaika, ma hope o ka hōʻike, a no ka maluhiluhi o ka hiki e hookuuia ke ao o waho; |
Uahi nuʻa huahelu huahelu | 0 ~ 100%; |
Uahi nuʻa huahelu pololei | ± 3%; |
pa alima | no ka mea silikone photovoltaic keena, malamalama EYI uku o ka 0% no ka hooholo ana o ka malamalama, malamalama EYI uku o ka 100% ka malamalama me ka uhi loa ma; |
Main puhiʻino hana puʻe | 276KPa (hoʻoneʻe); |