SL-FL39 DIN 4102 Smoke Density Fire Tester
DIN 4102 Material de construción flamabilidade Equipo de proba / Smoke densidade lume Tester
Product introduction of the Smoke Density Fire Tester
Axeitado utilizado para medir a característica de produción de somke de material de construción, baixo condicións controladas de combustión ou a descomposición, e tamén pode ser usado para outros plásticos.
Standards
ASTM D 2843, DIN 4102
Product Specification of the Smoke Density Fire Tester
|
Maximum smoke density (MSD) and smoke density (SDR) for the specimen |
0-100% continuously measurable and automatically calculated |
|
With the standard optical correction error |
not more than 3%; each device is equipped with three standard filters, proof of light source data, representative |
|
Bunsen lamp working pressure |
(210 ± 5) KPa |
|
Bunsen lamp on the sample to impose a flame |
4min |
|
Automatic timing, automatic ignition, automatic smoke; luminous flux can be phased linear calibration test data more acurrate;
|
|
|
Touch Screen |
5 inch effective display size 11cm wide 6.28cm; b. Resolution: 800 * 480 |
|
communication interface |
RS232, 3.3V CMOS or TTL |
|
serial port d. storage capacity |
1G |
|
Gas source |
95% propane gas, or the same purity of the gas (customer-owned) |
|
dimensión |
long * wide * high 740 * 500 * high 900 (mm) |
Fetures:
a. Size: 5 inch effective display size 11cm wide 6.28cm;
b. Resolution: 800 * 480
c. communication interface RS232, 3.3V CMOS or TTL, serial port
d. storage capacity: 1G
e. Using pure hardware FPGA driver display, "zero" start time, power can run
f. using M3 + FPGA architecture, M3 is responsible for instruction resolution, FPGA focus TFT display, speed and reliability are leading the same kind of program
g. The main controller uses low-power processor, automatically enter the energy-saving mode
Product parameters of the Smoke Density Fire Tester
| facho de lume | para os estudantes de luz, lonxitude 260 mm, un bocal de diámetro 0,13 milímetros, de 45 ° ángulo coa caixa de tabaco; |
| sistema fotoeléctrico | fonte de luz para a lámpada, a potencia de 15W, operando 6V tensión; |
| sistema de escape | a máquina está equipada cunha ventoinha de forte, tras o exame, os gases de escape poden descargadas ao aire libre; |
| Fume intervalo de medida de densidade | 0 ~ 100%; |
| precisión da medida de densidade do fume | ± 3%; |
| recebedor | para as culas fotovoltaicas de silicio, a taxa de transmisión de luz de 0% para o paso de taxa de transmisión de luz, a luz de luz 100% sen cubrir completamente a través; |
| presión de traballo fogar principal | 276KPa (axustable); |
