SL-FL39 DIN 4102 Smoke Density Fire Tester
DIN 4102 อาคารวัสดุไวไฟอุปกรณ์ทดสอบ / ควันหนาแน่นไฟ Tester
Product introduction of the Smoke Density Fire Tester
เหมาะใช้สำหรับการวัดลักษณะ somke ผลิตของวัสดุก่อสร้างภายใต้เงื่อนไขที่ควบคุมการเผาไหม้หรือการสลายตัวและยังสามารถนำมาใช้สำหรับพลาสติกอื่น ๆ
มาตรฐาน
ASTM D 2843, DIN 4102
Product Specification of the Smoke Density Fire Tester
Maximum smoke density (MSD) and smoke density (SDR) for the specimen |
0-100% continuously measurable and automatically calculated |
With the standard optical correction error |
not more than 3%; each device is equipped with three standard filters, proof of light source data, representative |
Bunsen lamp working pressure |
(210 ± 5) KPa |
Bunsen lamp on the sample to impose a flame |
4min |
Automatic timing, automatic ignition, automatic smoke; luminous flux can be phased linear calibration test data more acurrate;
|
|
Touch Screen |
5 inch effective display size 11cm wide 6.28cm; b. Resolution: 800 * 480 |
communication interface |
RS232, 3.3V CMOS or TTL |
serial port d. storage capacity |
1G |
Gas source |
95% propane gas, or the same purity of the gas (customer-owned) |
มิติ |
long * wide * high 740 * 500 * high 900 (mm) |
Fetures:
a. Size: 5 inch effective display size 11cm wide 6.28cm;
b. Resolution: 800 * 480
c. communication interface RS232, 3.3V CMOS or TTL, serial port
d. storage capacity: 1G
e. Using pure hardware FPGA driver display, "zero" start time, power can run
f. using M3 + FPGA architecture, M3 is responsible for instruction resolution, FPGA focus TFT display, speed and reliability are leading the same kind of program
g. The main controller uses low-power processor, automatically enter the energy-saving mode
Product parameters of the Smoke Density Fire Tester
โคมไฟเผาไหม้ | สำหรับนักเรียนสว่าง, ความยาว 260mm หัวฉีดขนาดเส้นผ่าศูนย์กลาง 0.13mm 45 องศาพร้อมกล่องควัน; |
ระบบอิเล็กทริค | แหล่งกำเนิดแสงสำหรับโคมไฟพลังงาน 15W ปฏิบัติการ 6V แรงดันไฟฟ้า; |
ระบบไอเสีย | เครื่องเป็นอุปกรณ์ที่มีแฟนที่แข็งแกร่งหลังจากการทดสอบไอเสียสามารถจะกลางแจ้งประจุ; |
สูบบุหรี่ช่วงการวัดความหนาแน่น | 0 ~ 100%; |
สูบบุหรี่แม่นยำในการวัดความหนาแน่น | ± 3%; |
ผู้รับ | สำหรับเซลล์ซิลิคอนเซลล์แสงอาทิตย์อัตราการส่งผ่านแสง 0% สำหรับเนื้อเรื่องของแสงอัตราการส่งผ่านแสงของแสง 100% โดยไม่ปิดบังสมบูรณ์ผ่าน; |
หลักความดันเตาทำงาน | 276KPa (ปรับ); |