SL-FL39 DIN 4102 Smoke Density Fire Tester
DIN 4102 Costruzione infiammabilità materiale apparecchiatura di collaudo / densità di fumo del fuoco Tester
Product introduction of the Smoke Density Fire Tester
Adatto utilizzato per misurare la caratteristica somke produttrici di materiale da costruzione in condizioni controllate di combustione o decomposizione, e inoltre può essere utilizzato per altre materie plastiche.
Standards
ASTM D 2843, DIN 4102
Product Specification of the Smoke Density Fire Tester
Maximum smoke density (MSD) and smoke density (SDR) for the specimen |
0-100% continuously measurable and automatically calculated |
With the standard optical correction error |
not more than 3%; each device is equipped with three standard filters, proof of light source data, representative |
Bunsen lamp working pressure |
(210 ± 5) KPa |
Bunsen lamp on the sample to impose a flame |
4min |
Automatic timing, automatic ignition, automatic smoke; luminous flux can be phased linear calibration test data more acurrate;
|
|
Touch Screen |
5 inch effective display size 11cm wide 6.28cm; b. Resolution: 800 * 480 |
communication interface |
RS232, 3.3V CMOS or TTL |
serial port d. storage capacity |
1G |
Gas source |
95% propane gas, or the same purity of the gas (customer-owned) |
Dimensione |
long * wide * high 740 * 500 * high 900 (mm) |
Fetures:
a. Size: 5 inch effective display size 11cm wide 6.28cm;
b. Resolution: 800 * 480
c. communication interface RS232, 3.3V CMOS or TTL, serial port
d. storage capacity: 1G
e. Using pure hardware FPGA driver display, "zero" start time, power can run
f. using M3 + FPGA architecture, M3 is responsible for instruction resolution, FPGA focus TFT display, speed and reliability are leading the same kind of program
g. The main controller uses low-power processor, automatically enter the energy-saving mode
Product parameters of the Smoke Density Fire Tester
lampada accesa | per gli studenti deboli, lunghezza 260 millimetri, diametro dell'ugello 0,13 millimetri, 45 ° con la cassa fumi; |
sistema fotoelettrico | sorgente di luce per la lampada, potenza 15W, operando tensione 6V; |
Impianto di scarico | la macchina è dotata di un forte ventilatore, dopo la prova, il gas di scarico può essere all'aperto scariche; |
Fumo campo di misura della densità | 0 ~ 100%; |
Fumo precisione di misura della densità | ± 3%; |
Ricevitore | per le celle fotovoltaiche in silicio, trasmissione di luce del 0% per il passaggio, trasmissione di luce della luce del 100% luce senza coperchio completamente attraverso; |
Principale pressione al bruciatore di lavoro | 276KPa (regolabile); |