SL-FL39 DIN 4102 Smoke Density Fire Tester
DIN 4102 مواد و مصالح ساختمانی اشتعال تجهیزات تست / دود تراکم آتش تستر
Product introduction of the Smoke Density Fire Tester
مناسب برای اندازه گیری مشخصه somke تولید مصالح ساختمانی تحت شرایط کنترل احتراق یا تجزیه و همچنین می تواند برای دیگر پلاستیک استفاده می شود.
استاندارد
ASTM D 2843، DIN 4102
Product Specification of the Smoke Density Fire Tester
Maximum smoke density (MSD) and smoke density (SDR) for the specimen |
0-100% continuously measurable and automatically calculated |
With the standard optical correction error |
not more than 3%; each device is equipped with three standard filters, proof of light source data, representative |
Bunsen lamp working pressure |
(210 ± 5) KPa |
Bunsen lamp on the sample to impose a flame |
4min |
Automatic timing, automatic ignition, automatic smoke; luminous flux can be phased linear calibration test data more acurrate;
|
|
Touch Screen |
5 inch effective display size 11cm wide 6.28cm; b. Resolution: 800 * 480 |
communication interface |
RS232, 3.3V CMOS or TTL |
serial port d. storage capacity |
1G |
Gas source |
95% propane gas, or the same purity of the gas (customer-owned) |
بعد، ابعاد، اندازه |
long * wide * high 740 * 500 * high 900 (mm) |
Fetures:
a. Size: 5 inch effective display size 11cm wide 6.28cm;
b. Resolution: 800 * 480
c. communication interface RS232, 3.3V CMOS or TTL, serial port
d. storage capacity: 1G
e. Using pure hardware FPGA driver display, "zero" start time, power can run
f. using M3 + FPGA architecture, M3 is responsible for instruction resolution, FPGA focus TFT display, speed and reliability are leading the same kind of program
g. The main controller uses low-power processor, automatically enter the energy-saving mode
Product parameters of the Smoke Density Fire Tester
لامپ سوزاندن | برای دانش آموزان روشن، طول 260mm، نازل 0.13mm قطر، زاویه 45 درجه با جعبه دود؛ |
سیستم فوتوالکتریک | منبع نور برای لامپ، قدرت 15W، عامل 6V ولتاژ؛ |
سیستم اگزوز | دستگاه با یک فن قوی مجهز شده است، پس از آزمون، اگزوز می تواند خارج از منزل تخلیه؛ |
دود محدوده اندازه گیری چگالی | 0 ~ 100٪؛ |
دود دقت اندازه گیری چگالی | ± 3٪؛ |
گیرنده | برای سلول های فوتوولتائیک سیلیکونی، نرخ انتقال نور از 0٪ برای عبور از نور، سرعت انتقال نور از نور 100٪ بدون پوشش کامل از طریق؛ |
فشار مشعل کار اصلی | 276KPa (قابل تنظیم). |