SL-FL39 DIN 4102 Smoke Density Fire Tester
Din 4102 Building Material Flammability Testing Taputapu / Smoke Kiato Fire Kaiwhakamātau
Product introduction of the Smoke Density Fire Tester
E tika ana whakamahia mō te ine i te āhuatanga somke-whakaputa o te hanga rauemi i raro i te huru te mana o te parariraa whāwehe ranei, a hoki e taea te whakamahi mō te tahi atu kirihou.
paerewa
ASTM D 2843, din 4102
Product Specification of the Smoke Density Fire Tester
|
Maximum smoke density (MSD) and smoke density (SDR) for the specimen |
0-100% continuously measurable and automatically calculated |
|
With the standard optical correction error |
not more than 3%; each device is equipped with three standard filters, proof of light source data, representative |
|
Bunsen lamp working pressure |
(210 ± 5) KPa |
|
Bunsen lamp on the sample to impose a flame |
4min |
|
Automatic timing, automatic ignition, automatic smoke; luminous flux can be phased linear calibration test data more acurrate;
|
|
|
Touch Screen |
5 inch effective display size 11cm wide 6.28cm; b. Resolution: 800 * 480 |
|
communication interface |
RS232, 3.3V CMOS or TTL |
|
serial port d. storage capacity |
1G |
|
Gas source |
95% propane gas, or the same purity of the gas (customer-owned) |
|
ahu |
long * wide * high 740 * 500 * high 900 (mm) |
Fetures:
a. Size: 5 inch effective display size 11cm wide 6.28cm;
b. Resolution: 800 * 480
c. communication interface RS232, 3.3V CMOS or TTL, serial port
d. storage capacity: 1G
e. Using pure hardware FPGA driver display, "zero" start time, power can run
f. using M3 + FPGA architecture, M3 is responsible for instruction resolution, FPGA focus TFT display, speed and reliability are leading the same kind of program
g. The main controller uses low-power processor, automatically enter the energy-saving mode
Product parameters of the Smoke Density Fire Tester
| He wera rama | hoki marama nga ākonga, roa 260mm, pupuha diameter 0.13mm, 45 ° koki ki te pouaka paowa; |
| pūnaha hiko | puna marama mo te rama, te mana 15W, whakahaere ngaohiko 6V; |
| pūnaha ākihau | rawa te mīhini e ki te mea powhiriwhiri kaha, i muri i te whakamātautau, ka taea e te whakapau hei waho tukua; |
| Paowa awhe kiato inenga | 0 ~ 100%; |
| Paowa tika kiato inenga | ± 3%; |
| kaiwhiwhi | mo nga pūtau silicon photovoltaic, auau tuku marama o 0% mo te wahi o te marama, auau tuku marama o 100% marama, kahore taupoki rawa i roto i; |
| pēhanga pūwera mahi Main | 276KPa (te whakarite); |
