SL-FL39 DIN 4102 Smoke Density Fire Tester
DIN 4102 Building Material Eldfimi Testing Equipment / Smoke Þéttleiki Fire Tester
Product introduction of the Smoke Density Fire Tester
Hentugur notað til að mæla somke gefa af sér afurðir sem eru einkennandi fyrir efni bygging með stýrðu ástand bruna eða niðurbrot, og einnig er hægt að nota til að öðru plasti.
staðlar
ASTM D 2843, DIN 4102
Product Specification of the Smoke Density Fire Tester
Maximum smoke density (MSD) and smoke density (SDR) for the specimen |
0-100% continuously measurable and automatically calculated |
With the standard optical correction error |
not more than 3%; each device is equipped with three standard filters, proof of light source data, representative |
Bunsen lamp working pressure |
(210 ± 5) KPa |
Bunsen lamp on the sample to impose a flame |
4min |
Automatic timing, automatic ignition, automatic smoke; luminous flux can be phased linear calibration test data more acurrate;
|
|
Touch Screen |
5 inch effective display size 11cm wide 6.28cm; b. Resolution: 800 * 480 |
communication interface |
RS232, 3.3V CMOS or TTL |
serial port d. storage capacity |
1G |
Gas source |
95% propane gas, or the same purity of the gas (customer-owned) |
Mál |
long * wide * high 740 * 500 * high 900 (mm) |
Fetures:
a. Size: 5 inch effective display size 11cm wide 6.28cm;
b. Resolution: 800 * 480
c. communication interface RS232, 3.3V CMOS or TTL, serial port
d. storage capacity: 1G
e. Using pure hardware FPGA driver display, "zero" start time, power can run
f. using M3 + FPGA architecture, M3 is responsible for instruction resolution, FPGA focus TFT display, speed and reliability are leading the same kind of program
g. The main controller uses low-power processor, automatically enter the energy-saving mode
Product parameters of the Smoke Density Fire Tester
eldslogi | að nemendur ljós, lengd 260mm, stútur þvermál 0.13mm, 45 ° horn með reyk kassi; |
photoelectric kerfi | ljósgjafi fyrir lampa, máttur 15W, starfa spenna 6V; |
Útblásturskerfi | Vélin er búin með sterka viftu, að lokinni prófun, útblástur er hægt að hleypa úti; |
Þéttleiki reyksins mælisvið | 0 ~ 100%; |
Þéttleiki reyksins mæling nákvæmni | ± 3%; |
Viðtakandi | fyrir sílikon photovoltaic frumur, ljós sending hlutfall af 0% til passage ljós, ljós sending hlutfall af 100% af léttri án þess að ná alveg gegnum geislabrautina; |
Helstu brennari vinnuþrýsting | 276KPa (stillanlegt); |