SL-FL39 DIN 4102 Smoke Density Fire Tester
DIN 4102 Byggematerialer Brændbarhed Test Udstyr / røgtæthed Fire Tester
Product introduction of the Smoke Density Fire Tester
Egnet anvendes til måling af somke-producerende karakteristisk for byggemateriale under kontrolleret tilstand forbrænding eller nedbrydning, og også kan bruges til andre plastmaterialer.
standarder
ASTM D 2843, DIN 4102
Product Specification of the Smoke Density Fire Tester
|
Maximum smoke density (MSD) and smoke density (SDR) for the specimen |
0-100% continuously measurable and automatically calculated |
|
With the standard optical correction error |
not more than 3%; each device is equipped with three standard filters, proof of light source data, representative |
|
Bunsen lamp working pressure |
(210 ± 5) KPa |
|
Bunsen lamp on the sample to impose a flame |
4min |
|
Automatic timing, automatic ignition, automatic smoke; luminous flux can be phased linear calibration test data more acurrate;
|
|
|
Touch Screen |
5 inch effective display size 11cm wide 6.28cm; b. Resolution: 800 * 480 |
|
communication interface |
RS232, 3.3V CMOS or TTL |
|
serial port d. storage capacity |
1G |
|
Gas source |
95% propane gas, or the same purity of the gas (customer-owned) |
|
Dimension |
long * wide * high 740 * 500 * high 900 (mm) |
Fetures:
a. Size: 5 inch effective display size 11cm wide 6.28cm;
b. Resolution: 800 * 480
c. communication interface RS232, 3.3V CMOS or TTL, serial port
d. storage capacity: 1G
e. Using pure hardware FPGA driver display, "zero" start time, power can run
f. using M3 + FPGA architecture, M3 is responsible for instruction resolution, FPGA focus TFT display, speed and reliability are leading the same kind of program
g. The main controller uses low-power processor, automatically enter the energy-saving mode
Product parameters of the Smoke Density Fire Tester
| Brændende lampe | for de studerende lys, længde 260 mm, diameter 0,13 mm dyse, 45 ° vinkel med røgen box; |
| fotoelektrisk System | lyskilde til lampen, magt 15W, driftsspænding 6V; |
| Udstødningssystem | maskinen er udstyret med en stærk fan, efter testen, kan udstødningen udtømmes udendørs; |
| Røgmåling densitetsområde | 0 ~ 100%; |
| Røg densitetsmåling nøjagtighed | ± 3%; |
| Modtager | for silicium solceller, lystransmission på 0% til passage af lys, lystransmission på 100% lys uden låg helt igennem; |
| Vigtigste brænder arbejdstryk | 276KPa (justerbar); |
