Densità di fumo Camera
Smoke Density Chamber Electronic ignition system with PID temperature controller Analysis of various gases
Prodotto Profilo of Densità di fumo Camera
Questo strumento è stato stabilito per molti anni ed è ampiamente utilizzato in tutti i settori industriali per la determinazione di fumo generato da materiali solidi e assemblaggi montato in posizione verticale all'interno di una camera chiusa.
Prodotto parametri di Densità di fumo Camera
Taglia | 1560 mm (W) x 2220 mm x (H) x 1060 mm |
Peso | 190KG |
Standards | AITM 2.0007A,AITM 2.0007B,AITM 3.0005、BSS 7238,BSS 7239、FAR PART 25 APPENDIX F Part V |
Applicazione | Aviation |
Elettrico | 110V AC 60Hz / 230V AC 50Hz, 15A |
Temperatura ambiente | Operating 10°C to 35°C |
Product Feature di Densità di fumo Camera
Powder coated liner removable for repair/replacement. Powder coated exterior.
Large tempered double glazed door for easy viewing and cleaning.
PID temperature controller for constant furnace setting.
Coil type tubular radiant heater with integrated thermocouple. Master electrical shut-off switch with maintenance lockout. Pneumatic actuated test sample transport system for repeatability of tests.
Electronic ignition system.
Calibrated flowmeters Propane and air flow measurement. Master gas on/off control with safety latching circuit to prevent gas flow following power interruption.
2 removable 6 flame pilot burners for normal test and wire test. 4 ports on roof of chamber for toxicity analysis.
3 stainless steel sample holders complete with backer board, spring and spring pin.
1 blank sample for wall protection. Wire sample holder
Calibration system including 1 water cooled heat flux gauge (0-5 W/cm2), holder and integral cooling system.
3 optical filters for linearity calibration.
Furnace location and pilot burner location tools. Pilot burner cleaning tool.
Customized data acquisition software and hardware for calibration and testing with USB interface for connection to external computer (administration rights required for computer)
Data stored in csv format for easy exporting to spreadsheet programs.
Spare parts kit including
Tubo fotomoltiplicatore forno lampada
pilota standard bruciatore
Guarnizione porta
guarnizioni Vent
Vent attuatore
Aspiratore
gas / aria elettrovalvola
fusibili kit
sistema di computer non incluso, ma può essere fornito se requeste