Chambre Densité de fumée
Smoke Density Chamber Electronic ignition system with PID temperature controller Analysis of various gases
Profil du produit of Chambre Densité de fumée
Cet instrument a été mis en place depuis de nombreuses années et est largement utilisé dans tous les secteurs industriels pour la détermination de la fumée produite par des matières solides et des ensembles montés en position verticale à l'intérieur d'une chambre fermée.
Produit paramètres de Chambre Densité de fumée
| Taille | 1560 mm (W) x 2220 mm x (H) x 1060 mm |
| Poids | 190KG |
| Normes | AITM 2.0007A，AITM 2.0007B，AITM 3.0005、BSS 7238，BSS 7239、FAR PART 25 APPENDIX F Part V |
| Application | Aviation |
| Électrique | 110V AC 60Hz / 230V AC 50Hz, 15A |
| Température ambiante | Operating 10°C to 35°C |
Product Fcial de Chambre Densité de fumée
Powder coated liner removable for repair/replacement. Powder coated exterior.
Large tempered double glazed door for easy viewing and cleaning.
PID temperature controller for constant furnace setting.
Coil type tubular radiant heater with integrated thermocouple. Master electrical shut-off switch with maintenance lockout. Pneumatic actuated test sample transport system for repeatability of tests.
Electronic ignition system.
Calibrated flowmeters Propane and air flow measurement. Master gas on/off control with safety latching circuit to prevent gas flow following power interruption.
2 removable 6 flame pilot burners for normal test and wire test. 4 ports on roof of chamber for toxicity analysis.
3 stainless steel sample holders complete with backer board, spring and spring pin.
1 blank sample for wall protection. Wire sample holder
Calibration system including 1 water cooled heat flux gauge (0-5 W/cm2), holder and integral cooling system.
3 optical filters for linearity calibration.
Furnace location and pilot burner location tools. Pilot burner cleaning tool.
Customized data acquisition software and hardware for calibration and testing with USB interface for connection to external computer (administration rights required for computer)
Data stored in csv format for easy exporting to spreadsheet programs.
Spare parts kit including
Tube photomultiplicateur four lampe
pilote standard brûleur
joint de porte
joints Vent
Vent actionneur
ventilateur d' échappement de
gaz / air solénoïde
kit Fuse
Système informatique non inclus mais peut être fourni si requeste
