OSU míry uvolňování tepla Tester
OSU Heat Release Rate Tester Stainless Steel Combustion Test Chamber Equipped
Informace o výrobku z OSU hHeat Release Rate Tester
OSU teplo rychlost uvolňování Tester schválen FAA na Federálním leteckým úřadem Spojených států byl původně navržený Smithem z Ohio State University v roce 1972 a později se stal FAA určený spalovací zkušební přístroj pro testování rychlosti uvolňování tepla letecké materiály. Zkušební normy FAR Part 25 Dodatek F Part IV, Airbus AITM 2.00. 06, Boeing BSS 7322.
Výkonové charakteristiky OSU míry uvolňování tepla Tester
1. Stainless steel combustion test chamber with high temperature glass observation window;
2. The heat radiation source is 4 Glowbars heating rods, which can provide 35KW/M2 heat radiation flux.
3. Two independent PID temperature controllers are used for heating temperature control.
4. Equipped with fully automatic pneumatic sample propulsion device and shielding door device;
5. Equipped with upper burner and movable lower burner;
6. Rotor flowmeter can be used to adjust the gas flow rate of upper and lower burners.
7. Equipped with movable T-type calibration burner device and flow controller;
8. Mass flow controller is applied to thermopile temperature calibration automatically.
9. Water-cooled heat flow meter is equipped with cooling mode to measure the heat radiation flux of the fire surface.
10. The air temperature control device can provide constant temperature and flow air for the test chamber.
11. The orifice flowmeter is used to measure the flow pressure entering the test bin.
12. Equipped with data acquisition system and heat release standard test software.
Produktové parametry of OSU Heat Release Rate Tester
Velikost | 760 mm (š) x 1850 mm x (H) x 850 mm (D) |
Hmotnost | 218KG |
požadavky na elektřinu | 220 V, 35 zesilovače |
Teplota okolí | 10 ℃ až 35 ℃ |
pomocný Gas | Konstantní teplota a konstantní proud plynu |
spalin | metan |
Standard | AITM 2,0006, BSS 7322, FAR část 25 PŘÍLOHA F Část IV |
Aplikace | Letectví Materials |