OSU Heat Release Rate Tester
OSU Heat Release Rate Tester Stainless Steel Combustion Test Chamber Equipped
Produktinformation om OSU hHeat Release Rate Tester
OSU brandeffekt testare som godkänts av FAA av Federal Aviation Administration i USA ritades ursprungligen av Smith från Ohio State University 1972, och blev senare en FAA utsedd förbränningstestinstrument för att testa brandeffekten av luftfarts material. Test standarder är FAR Part 25 Bilaga F del IV, Airbus AITM 2,00. 06, Boeing BSS 7322.
Prestandaegenskaper OSU Heat Release Rate Tester
1. Stainless steel combustion test chamber with high temperature glass observation window;
2. The heat radiation source is 4 Glowbars heating rods, which can provide 35KW/M2 heat radiation flux.
3. Two independent PID temperature controllers are used for heating temperature control.
4. Equipped with fully automatic pneumatic sample propulsion device and shielding door device;
5. Equipped with upper burner and movable lower burner;
6. Rotor flowmeter can be used to adjust the gas flow rate of upper and lower burners.
7. Equipped with movable T-type calibration burner device and flow controller;
8. Mass flow controller is applied to thermopile temperature calibration automatically.
9. Water-cooled heat flow meter is equipped with cooling mode to measure the heat radiation flux of the fire surface.
10. The air temperature control device can provide constant temperature and flow air for the test chamber.
11. The orifice flowmeter is used to measure the flow pressure entering the test bin.
12. Equipped with data acquisition system and heat release standard test software.
Produkt parametrar of OSU Heat Release Rate Tester
Storlek | 760mm (B) x 1850mm x (H) x 850mm (D) |
Vikt | 218KG |
elektricitet krav | 220 V, 35 Amps |
Omgivningstemperatur | 10 ℃ till 35 ℃ |
hjälpgas | Konstant temperatur och konstant ström Gas |
förbrännings~~POS=TRUNC gas | metan |
Standard | AITM 2,0006, BSS 7322, FAR DEL 25 APPENDIX F del IV |
tillämpningar | Aviation Materials |