OSU szybkość uwalniania ciepła Tester
OSU Heat Release Rate Tester Stainless Steel Combustion Test Chamber Equipped
Informacje o produkcie z OSU hheat Tester szybkość uwalniania
Tester szybkość wydzielania ciepła OSU zatwierdzony przez FAA z Aviation Administration Federalnej Stanów Zjednoczonych został pierwotnie zaprojektowany przez Smitha z Ohio State University w 1972 roku, a później stał się FAA wyznaczony spalanie przyrząd pomiarowy do testowania szybkości uwalniania ciepła materiałów lotniczych. Normy badań są FAR Part 25 Dodatek F Część IV Airbus AITM 2,00. 06, Boeing BSS 7322.
Kryteria skuteczności OSU szybkość uwalniania ciepła Tester
1. Stainless steel combustion test chamber with high temperature glass observation window;
2. The heat radiation source is 4 Glowbars heating rods, which can provide 35KW/M2 heat radiation flux.
3. Two independent PID temperature controllers are used for heating temperature control.
4. Equipped with fully automatic pneumatic sample propulsion device and shielding door device;
5. Equipped with upper burner and movable lower burner;
6. Rotor flowmeter can be used to adjust the gas flow rate of upper and lower burners.
7. Equipped with movable T-type calibration burner device and flow controller;
8. Mass flow controller is applied to thermopile temperature calibration automatically.
9. Water-cooled heat flow meter is equipped with cooling mode to measure the heat radiation flux of the fire surface.
10. The air temperature control device can provide constant temperature and flow air for the test chamber.
11. The orifice flowmeter is used to measure the flow pressure entering the test bin.
12. Equipped with data acquisition system and heat release standard test software.
Produkt parametry of OSU Heat Release Rate Tester
Rozmiar | 760 mm (W) x 1850mm x (H) x 850 mm (A) |
Waga | 218KG |
zapotrzebowania na energię elektryczną | 220 V, 35 Amp |
Temperatura otoczenia | 10 ℃ do 35 ℃ |
Gaz pomocniczy | Stałej temperaturze i stałym Aktualny Gazu |
gaz spalinowy | metan |
Standard | AITM 2,0006, BSS 7322, FAR CZĘŚĆ 25 DODATEK F Część IV |
Aplikacje | Materiały dla lotnictwa |