OSU 열 방출 속도 테스터
OSU Heat Release Rate Tester Stainless Steel Combustion Test Chamber Equipped
제품 정보 OSU hHeat 출시 속도 테스터의
미국의 연방 항공국의 FAA의 승인 OSU 열 방출 속도 테스터는 원래 1972 년에 오하이오 주립 대학의 스미스에 의해 디자인, 이후 항공 재료의 열 방출 속도를 테스트하기위한 FAA 지정 연소 시험 장비되었다. 테스트 기준은 FAR 제 25 부록 F 파트 IV, 에어 버스 AITM 2.00입니다. 06, 보잉 BSS 7322.
OSU 열 방출 속도 시험기의 성능 특성
1. Stainless steel combustion test chamber with high temperature glass observation window;
2. The heat radiation source is 4 Glowbars heating rods, which can provide 35KW/M2 heat radiation flux.
3. Two independent PID temperature controllers are used for heating temperature control.
4. Equipped with fully automatic pneumatic sample propulsion device and shielding door device;
5. Equipped with upper burner and movable lower burner;
6. Rotor flowmeter can be used to adjust the gas flow rate of upper and lower burners.
7. Equipped with movable T-type calibration burner device and flow controller;
8. Mass flow controller is applied to thermopile temperature calibration automatically.
9. Water-cooled heat flow meter is equipped with cooling mode to measure the heat radiation flux of the fire surface.
10. The air temperature control device can provide constant temperature and flow air for the test chamber.
11. The orifice flowmeter is used to measure the flow pressure entering the test bin.
12. Equipped with data acquisition system and heat release standard test software.
제품 매개 변수 of OSU Heat Release Rate Tester
크기 | 760mm (W) × 1,850mm × (H) × 850mm (D) |
무게 | 218KG |
전기 요구 사항 | 220 V, 35A |
주위 온도 | 35-10 ℃ ℃ |
보조 가스 | 일정한 온도 및 정전류 가스 |
연소 가스 | 메탄 |
표준 | AITM 2.0006, BSS 7322, FAR PART 25 부록 F 파트 IV |
응용 프로그램 | 항공 재료 |