의 제품 상세  the Single Burning Item
스테인레스 원심 팬, 300 도의 온도를 견딜 단계 교정 높은 온도의 요구 사항을 충족 할 수;
Diaphragm pump, flow rate: 400l / h, high temperature and corrosion resistance, used for sample gas collection;
The soot filter filter head is composed of solid PTFE with 0.5 um filter material inside;
Compressor condenser, cooling capacity 320KJ / h, dew point stability of 0.1 degrees, dew point static change of 0.1K, protection grade IP20;
Imported rotameter with a range of 0-5L/min to adjust the inlet flow of the analyzer;
Non-dispersive infrared CO2 analyzer: CO2: 0~10%;
A comprehensive measuring section with a length of 2155mm, equipped with a pressure probe, three thermocouples, a gas sampling probe and a white light system;
a gas sampling probe connected to the gas regulating device and the O2, CO2 inlet gas analyzer;
The light attenuation system is an incandescent light type, and is mounted on the side pipe of the exhaust pipe by a flexible joint;
A lens system for collecting light into a parallel beam of at least 20 mm in diameter. The light-emitting hole of the phototube should be located at the focus of the lens in front of it, and its diameter (d) should be determined according to the focal length (f) of the lens such that d/f is less than 0.04;
Detector and silicon photodiode probe, the photoelectric detection chamber has 0.1% linear stability, 10-bit measurement range, and the spectral distribution responsivity of the silicon photodiode is consistent with CIE (lighting curve), and the standard function V(γ) can reach at least ±5% accuracy;
The 90% response time of the optical attenuation system should not exceed 3s;
Introducing air into the side tube to maintain the optical device in compliance with the required attenuation of light attenuation drift, which can be accomplished using compressed air;