Kiina OSU lämmönluovutustaso Tester valmistajat ja toimittajat | siluetti

OSU lämmönluovutustaso Tester

Lyhyt kuvaus:

OSU lämmönluovutustaso testaaja FAA Federal Aviation Administration Yhdysvallat oli alun perin suunnitellut Smith Ohio State University vuonna 1972, ja myöhemmin tuli FAA nimetty palamisen testi väline testaus lämmönluovutustaso ilmailutiedotuspalvelun materiaaleista.


  • Min.Order Määrä: 1 yksikkö
  • Hinta: Neuvoteltavissa
  • Paketti: Vaneri Case
  • Malli: SL833
  • Standardit: AITM 2,0006, BSS 7322, FAR OSA 25 LIITE F Osa IV
  • Tuotetiedot

    tuotteen Tunnisteet

    OSU Heat Release Rate Tester Stainless Steel Combustion Test Chamber Equipped

    Tuotetiedot  ja OSU hHeat vapautumisnopeuteen Tester

    The OSU heat release rate tester approved by FAA of the Federal Aviation Administration of the United States was originally designed by Smith of Ohio State University in 1972, and later became a FAA designated combustion test instrument for testing the heat release rate of Aeronautical materials. The test standards are FAR Part 25 Appendix F Part IV, Airbus AITM 2.00. 06, Boeing BSS 7322.

    Suoritusarvot OSU lämmönluovutustaso Tester

    1. Stainless steel combustion test chamber with high temperature glass observation window;
    2. The heat radiation source is 4 Glowbars heating rods, which can provide 35KW/M2 heat radiation flux.
    3. Two independent PID temperature controllers are used for heating temperature control.
    4. Equipped with fully automatic pneumatic sample propulsion device and shielding door device;
    5. Equipped with upper burner and movable lower burner;
    6. Rotor flowmeter can be used to adjust the gas flow rate of upper and lower burners.
    7. Equipped with movable T-type calibration burner device and flow controller;
    8. Mass flow controller is applied to thermopile temperature calibration automatically.
    9. Water-cooled heat flow meter is equipped with cooling mode to measure the heat radiation flux of the fire surface.
    10. The air temperature control device can provide constant temperature and flow air for the test chamber.
    11. The orifice flowmeter is used to measure the flow pressure entering the test bin.
    12. Equipped with data acquisition system and heat release standard test software.

    Tuotteen  parametrit of OSU Heat Release Rate Tester

     Koko  760mm (L) x 1850mm x (H) x 850mm (D)
     Paino  218KG
     sähkö vaatimukset  220 V, 35 A
     Ympäristön lämpötila  10 ℃ 35 ℃
     ylimääräiset Gas  Lämpötila ja jatkuva Nykyinen Gas
     savukaasun  metaani
     standardi   AITM 2,0006, BSS 7322, FAR OSA 25 LIITE F Osa IV
     Sovellukset  Ilmailu Materiaalit

     


  • Edellinen:
  • Seuraava:

  • Kirjoita viestisi tähän ja lähetä se meille