Saina OSU vevela Faamatuu Fua faatatau Tester Gaosi ma e tuuina | tafailagi

OSU Faamatuu vevela Fua faatatau Tester

Faamatalaga puupuu:

O le fua faatatau tester faamatuu vevela OSU faamaonia e FAA o le Malo o Vaalele Pulega o na uluai fuafuaina le Iunaite Setete e Smith o Ohio Iunivesite o le Setete i le 1972, ma mulimuli ane avea ma se meafaigaluega suega combustion tofia FAA mo tofotofoina ai le fua faatatau o le tatalaina i tua le vevela o mea Aeronautical.


  • Min.Order Aotelega: 1 iunite
  • Tau: o feagaiga tau tupe
  • Afifi: Mataupu Plywood
  • Faataitaiga: SL833
  • Tulaga Faatonuina: AITM 2,0006, BSS 7322, MAMAO VAEGA 25 FAAOPOOPOGA F Vaega IV
  • Faamatalaga oloa

    pine o oloa

    OSU Heat Release Rate Tester Stainless Steel Combustion Test Chamber Equipped

    Faamatalaga oloa  o OSU hHeat Faamatuu Fua faatatau Tester

    The OSU heat release rate tester approved by FAA of the Federal Aviation Administration of the United States was originally designed by Smith of Ohio State University in 1972, and later became a FAA designated combustion test instrument for testing the heat release rate of Aeronautical materials. The test standards are FAR Part 25 Appendix F Part IV, Airbus AITM 2.00. 06, Boeing BSS 7322.

    Faatinoga o Galuega uiga o OSU Faamatuu vevela Fua faatatau Tester

    1. Stainless steel combustion test chamber with high temperature glass observation window;
    2. The heat radiation source is 4 Glowbars heating rods, which can provide 35KW/M2 heat radiation flux.
    3. Two independent PID temperature controllers are used for heating temperature control.
    4. Equipped with fully automatic pneumatic sample propulsion device and shielding door device;
    5. Equipped with upper burner and movable lower burner;
    6. Rotor flowmeter can be used to adjust the gas flow rate of upper and lower burners.
    7. Equipped with movable T-type calibration burner device and flow controller;
    8. Mass flow controller is applied to thermopile temperature calibration automatically.
    9. Water-cooled heat flow meter is equipped with cooling mode to measure the heat radiation flux of the fire surface.
    10. The air temperature control device can provide constant temperature and flow air for the test chamber.
    11. The orifice flowmeter is used to measure the flow pressure entering the test bin.
    12. Equipped with data acquisition system and heat release standard test software.

    Oloa  tapulaa of OSU Heat Release Rate Tester

     fua  760mm (W) x 1850mm x (H) x 850mm (D)
     mamafa  218KG
     manaoga o le eletise  220 V, 35 Amps
     vevela Ambient  10 ℃ e 35 ℃
     ausilali kasa  Vevela Tumau ma le kesi i le taimi nei e le aunoa
     kasa Combustion  methane
     tūlaga   AITM 2,0006, BSS 7322, MAMAO VAEGA 25 FAAOPOOPOGA F Vaega IV
     talosaga  Mea vaalele

     


  • Talu:
  • Sosoo ai:

  • Tusi lau savali iinei ma auina mai ia i tatou