Kitajska OSU Hitrost sproščanja toplote Tester Proizvajalci in dobavitelji | Skyline

OSU Hitrost sproščanja toplote Tester

Kratek opis:

tester je hitrost sproščanja OSU toplote FAA Zvezne uprave za letalstvo Združenih državah, odobrenih je bil prvotno zasnovan Smith iz Ohio State University leta 1972, kasneje pa je postal FAA imenovani testni instrument zgorevanjem za testiranje na hitrost sproščanja toplote iz letalstva materialov.


  • Min.Order Količina: 1 enota
  • Cena: Po dogovoru
  • Paket: Vezane Case
  • Model: SL833
  • Standardi: AITM 2,0006, BSS 7322, FAR DEL 25 DODATEK F Part IV
  • Podrobnosti izdelka

    Značke izdelka

    OSU Heat Release Rate Tester Stainless Steel Combustion Test Chamber Equipped

    Podatki o izdelku  od OSU hHeat Release Oceni Tester

    The OSU heat release rate tester approved by FAA of the Federal Aviation Administration of the United States was originally designed by Smith of Ohio State University in 1972, and later became a FAA designated combustion test instrument for testing the heat release rate of Aeronautical materials. The test standards are FAR Part 25 Appendix F Part IV, Airbus AITM 2.00. 06, Boeing BSS 7322.

    Delovne lastnosti OSU Hitrost sproščanja toplote Tester

    1. Stainless steel combustion test chamber with high temperature glass observation window;
    2. The heat radiation source is 4 Glowbars heating rods, which can provide 35KW/M2 heat radiation flux.
    3. Two independent PID temperature controllers are used for heating temperature control.
    4. Equipped with fully automatic pneumatic sample propulsion device and shielding door device;
    5. Equipped with upper burner and movable lower burner;
    6. Rotor flowmeter can be used to adjust the gas flow rate of upper and lower burners.
    7. Equipped with movable T-type calibration burner device and flow controller;
    8. Mass flow controller is applied to thermopile temperature calibration automatically.
    9. Water-cooled heat flow meter is equipped with cooling mode to measure the heat radiation flux of the fire surface.
    10. The air temperature control device can provide constant temperature and flow air for the test chamber.
    11. The orifice flowmeter is used to measure the flow pressure entering the test bin.
    12. Equipped with data acquisition system and heat release standard test software.

    Izdelek  parametri of OSU Heat Release Rate Tester

     Velikost  760 mm (W) x 1850mm x (H) x 850mm (D)
     Utež  218KG
     zahteve za električno energijo  220 V, 35 Ojačevalci
     Sobna temperatura  10 ℃ do 35 ℃
     pomožna plina  Stalna temperatura in konstantna Trenutni plin
     Zgorevanje plina  metan
     Standardna   AITM 2,0006, BSS 7322, FAR DEL 25 DODATEK F Part IV
     aplikacije  Aviation materiali

     


  • Prejšnja:
  • Naprej:

  • Napišite sporočilo tukaj in nam ga pošljite