Hiina OSU Soojuse eraldumine Tester tootjad ja tarnijad | Skyline

OSU Soojuse eraldumine Tester

Lühike kirjeldus:

OSU soojuse vabanemise kiirust tester heaks kiidetud FAA Federal Aviation Administration Ameerika Ühendriigid algselt kavandatud Smith Ohio State University 1972. aastal ja hiljem sai FAA määratud põlemise test vahend katsetamiseks soojuse vabanemise kiirust Aeronautical materjale.


  • Min.Order Kogus: 1 üks
  • Hind: Kokkuleppel
  • Pakend: Vineeri Case
  • Mudel: SL833
  • Standardid: AITM 2,0006, BSS 7322, FAR OSA 25 LISA F IV osa
  • toote Detail

    toote märksõnad

    OSU Heat Release Rate Tester Stainless Steel Combustion Test Chamber Equipped

    Toote info  OSU hHeat Release Rate Tester

    The OSU heat release rate tester approved by FAA of the Federal Aviation Administration of the United States was originally designed by Smith of Ohio State University in 1972, and later became a FAA designated combustion test instrument for testing the heat release rate of Aeronautical materials. The test standards are FAR Part 25 Appendix F Part IV, Airbus AITM 2.00. 06, Boeing BSS 7322.

    Toimeomadused OSU Soojuse eraldumine Tester

    1. Stainless steel combustion test chamber with high temperature glass observation window;
    2. The heat radiation source is 4 Glowbars heating rods, which can provide 35KW/M2 heat radiation flux.
    3. Two independent PID temperature controllers are used for heating temperature control.
    4. Equipped with fully automatic pneumatic sample propulsion device and shielding door device;
    5. Equipped with upper burner and movable lower burner;
    6. Rotor flowmeter can be used to adjust the gas flow rate of upper and lower burners.
    7. Equipped with movable T-type calibration burner device and flow controller;
    8. Mass flow controller is applied to thermopile temperature calibration automatically.
    9. Water-cooled heat flow meter is equipped with cooling mode to measure the heat radiation flux of the fire surface.
    10. The air temperature control device can provide constant temperature and flow air for the test chamber.
    11. The orifice flowmeter is used to measure the flow pressure entering the test bin.
    12. Equipped with data acquisition system and heat release standard test software.

    Toote  parameetrid of OSU Heat Release Rate Tester

     suurus  760mm (W) x 1850mm x (H) x 850mm (D)
     kaal  218KG
     elektri nõuded  220 V, 35 Amps
     Ümbritsev temperatuur  10 ℃ kuni 35 ℃
     Abigaasi  Pidev temperatuuri ja pidev Praegune Gaas
     põlemisgaaside  metaani
     Standard   AITM 2,0006, BSS 7322, FAR OSA 25 LISA F IV osa
     Rakendused  Aviation materjalid

     


  • Eelmine:
  • Järgmine:

  • Kirjutage oma sõnum siia ja saatke see meile