PriceList for Roofing Test With Burning Brands - ISO 6722 Automotive Wires Flammability Testing Equipment – Skyline
PriceList for Roofing Test With Burning Brands - ISO 6722 Automotive Wires Flammability Testing Equipment – Skyline Detail:
ISO 6722 Fire Testing Equipment Automotive Single Core Wire / Cable Flammability Testing Equipment
Product introduction of the Automotive Wires Flammability Testing Equipment
Single wire / cable vertical combustion tester mainly for the conductor diameter greater than 8mm (section area is greater than 0.5mm2) or less than 8mm (section area less than 0.5mm2) of single wire and cable flammability evaluation. Suitable for lighting equipment, low-voltage electrical appliances, household appliances, electrical tools, electric motor, electric tools, electronic instruments, electrical instruments, electrical connectors and accessories such as electrical and electronic products and components of the research, production and quality inspection department. This section adopts the recommended product structure of the air mixing structure in Appendix B of GB18380.12-2008, and also meets the requirements of the quality inspection unit in detail.
Product parameters of the Automotive Wires Flammability Testing Equipment
|Burning gas using high purity propane gas||liquefied petroleum gas|
|Tested wires length:600mm(24 in)||Sample clamping Angle:45 degree|
|The bunsen burner has 13mm inlet hole and 10mm (3/8 in) nominal diameter, spray fire pipe outer flame diameter is 100mm (4in)||inner flame is 50 mm(1/2in),temperature of inner flame as least 900 degree celsius|
|The Bunsen burner flame should be put in the bottom of the samples and perpendicular to the axis of the sample||The tip of the inner flame role should be in the midpoint of the sample|
|Automatic ignition||flame burn the sample continue 15 seconds and be off automatically|
|After burning 15 seconds||will time the continued burning, complete the continued burning time until the continued burning crush out and put off the stop button|
|Burning gas is not supplied with the tester||it should be supplied by customer|
Product Feature and Application of the Automotive Wires Flammability Testing Equipment
Single cable vertical burning test is set by size Bunsen (Bunsen burner) and the specific gas source (Bing Wan), according to a certain flame height and some application of flame angle on the vertical state of the sample application to test ignition timing, ignition, combustion duration and combustion to assess its length flammable and fire hazard.
Product Details of the Automotive Wires Flammability Testing Equipment
Rated voltage 50 V MMS or below ground vehicles with low voltage electrical system of primary cable flame retardant test, automotive wires. This instrument is made of control panel, flammability chamber, Bunsen burner, Electromagnetic valve, High pressure ignition, Gas pipe, Pressure regulating valves,timer, Governing valve control wire
Product detail pictures:
Related Product Guide:
Our well-equipped facilities and excellent excellent management throughout all stages of creation enables us to guarantee total buyer satisfaction for PriceList for Roofing Test With Burning Brands - ISO 6722 Automotive Wires Flammability Testing Equipment – Skyline , The product will supply to all over the world, such as: Adelaide , United Kingdom , Portugal , We aim to become the modern enterprise with the commercial ideal of "Sincerity and confidence" and with the aim of "Offering customers the most sincere services and best quality products". We sincerely ask for your unchanged support and appreciate your kind advice and guidance.
By Ophelia from Costa rica - 2017.11.20 15:58
A good manufacturers, we have cooperated twice, good quality and good service attitude.
By Diana from San Diego - 2017.07.07 13:00