ISO 8124-1 Toys Testing Equipment 1.35LB Sharp Edge Tester

Short Description:

To determine whether accessible edges on toys are likely to cause injury. A self-adhesive PTFE tape is attached to a mandrel, which is then rotated for a single 360-degree revolution along the accessible edge being tested.


  • Min.Order Quantity: 1 unit
  • Price: Negotiable
  • Package : Plywood Case
  • Model: SL-S12
  • Standards: ASTM F963 4.7, EN 71-1 8.11, 16 CFR 1500.49, ISO 8124-1 5.8
  • Product Detail

    Product Tags

    ISO 8124-1 Toys Testing Equipment 1.35LB Sharp Edge Tester for Children Products

    Product introduction of the Sharp Edge Tester

    To determine whether accessible edges on toys are likely to cause injury. A self-adhesive PTFE tape is attached to a mandrel, which is then rotated for a single 360-degree revolution along the accessible edge being tested. If the tape is cut in half or longer in length (approx. 13 mm), the edge is identified as a hazardous sharp edge. Toys intended for use by children under 8 years old are subject to this requirement before or after use & abuse testing.

    Product parameters of the Sharp Edge Tester

     Size  (L*W*H)29*19*10cm
     Weight  3.5Kg
     Speed  1.00±0.08 In/s
     Fixed force  1.35LB
     Material  stainless steel
     Accessories  Tiefo Long Tape PTFE Tape A set of foot switches, a power charger, an operating manual
     Standard  ASTM F963 4.7, EN 71-1 8.11, 16 CFR 1500.49, ISO 8124-1 5.8,

    Product Feature and Application of the Sharp Edge Tester

    Test principle

    The steel shaft used to simulate children's fingers needs to be hardened. The surface Rockwell hardness should be no less than 40, the surface roughness should not be greater than 0.40 microns, and the diameter should be 9.35 mm ± 0.12 mm. A layer of simulated artificial skin tape was applied perpendicularly to a steel shaft wrapped with simulated artificial skin glue with a force of 6 N (1.35 lb). The steel shaft was constant tangent at 23 mm/sec ± 4 mm/sec. The speed is rotated for one week. Check the edge of the test to cut (cut) the simulated artificial skin adhesive paper. If cut (cut), the tested edge is defined as a potentially dangerous sharp edge.

    Application

    Used to determine whether the edge of a toy or item is a sharp edge with an unreasonable risk of injury.

    Product Details of the Sharp Edge Tester

     Usage and judgment results 1. Attach the PTFE adhesive tape to the mandrel as required, and then rotate the mandrel along the tested accessible edge by 360°. Check that the test adhesive tape is gravity-corrected. Whether the ball can pass the test template completely. The length of the cut. Calculate the percentage of the length of the cut tape. Judgment: If the adhesive tape is cut by 50% Split, the edge is considered to be a sharp edge. 2. The edge to be tested shall be the accessible edge determined after the accessibility test of the toy part or component. 3. If the touchable edge of the toy as a whole cannot be tested, in the case of simulating the toy as a whole, the accessible edge can be removed and tested separately. 4. The key to the sharp edge test is how to fix the detected edge and ensure that the mandrel is at right angles to the edge, and there is no phase between the mandrel and the edge during the test. For sports. 5. During the rotation of the mandrel, it should be ensured that the pressure applied to the mandrel is continuously stable.

     


  • Previous:
  • Next:

  • Write your message here and send it to us